i need help from start to finish. anything willl help or redirecting me to another thread would help too, im new at this stuff.
anything will help! thanks
Place the distributor on the workbench and remove the module retaining screws. Pull the right side of the module down the distributor mounting flange and back up to disengage the module terminal from the connector in the distributor base. The module may be pulled toward the flange and away from the distributor.
Do NOT attempt to lift the module from the mounting surface, except as explained above. The pins will break at the distributor module connector. To install:
Coat the base plate of the TFI ignition module uniformly with 1/32 inch of silicone dielectric compound WA-10 or equivalent.
Position the module on the distributor base mounting flange. Carefully position the module toward the distributor bowl and engage the three connector pins securely.
Install the retaining screws. Tighten to 15-35 inch lbs (1.7-4.0 Nm), starting with the upper right screw.
Install the distributor into the engine. Install the cap and wires.
Place the distributor on the workbench and remove the module retaining screws. Pull the right side of the module down the distributor mounting flange and back up to disengage the module terminal from the connector in the distributor base. The module may be pulled toward the flange and away from the distributor.
Do NOT attempt to lift the module from the mounting surface, except as explained above. The pins will break at the distributor module connector.
To install:
Coat the base plate of the TFI ignition module uniformly with 1/32 inch of silicone dielectric compound WA-10 or equivalent.
Position the module on the distributor base mounting flange. Carefully position the module toward the distributor bowl and engage the three connector pins securely.
Install the retaining screws. Tighten to 15-35 inch lbs (1.7-4.0 Nm), starting with the upper right screw.
Install the distributor into the engine. Install the cap and wires.
i don't know why you would have to remove the distributor i just changed mine about 6 months ago didn't have to remove the distributor but i did have to buy the special tool to remove the dang thing you can get it in the help aisle at autozone only like 5 bucks or so good luck
Status
Not open for further replies.
You have insufficient privileges to reply here.
Related Threads
?
?
?
?
?
Ford Mustang Forum
3.7M posts
229.4K members
Since 2001
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, builds, modifications, reviews, engine swaps, classifieds, troubleshooting, maintenance, and more!