[WarrenK631]

hey guys, i just found out about this site and i had a question about my 2.3l mustang.

i was wondering if there were any exhausts out there for a 2.3l or should i just go to a shop and have them custom fab one up for me

thanks,
Warren

[1mach1]

Welcome to AFM! Check out the V6 section for advice!

[WarrenK631]

thanks mach1 for the info

[ExtrmZ]

haha thats funny.. actually i need an exhaust for my car.. is your car a N/A, if it is i havent found a pre-fabbed exhaust.. i have found some stuff for a turbo engine, but you don't want to run that large of a diameter of piping.. it will hurt your performance.. i am still looking around, ill let you know what i find

[WarrenK631]

yeah our cars need back pressure and i havent been able to find a full exhaust, only a muffler so i think im just going to ask a muffler shop to see what they can do

[Mustanq]

You'll probably need them to make an exhaust for you. No higher diameter inlet/outlet than 2.25. Two inches is stock. For your muffler it has to be both offset inlet/outlet.