[LordLeverette]

Whats a good beefy sounding exhaust for a 2.3? Someday I plan to stick a Turbo coupe turbo in my engine (or swap the engine, we'll see when the time comes). Anyway, whats a good exhaust to get? I have my eye on the Flowmaster 40 series and the Thrush Turbo. The Thrush is cheaper, which is enticing, but I don't want to sound like a Honda Civic (And I'd love atleast to have a little HP boost out of it)

Any advice?

[heavy metal]

I would not use the Thrush.The Magnaflow sounds good,as well as some others.Check out the sound threads here for some ideas.

[LordLeverette]

Well, I've read up a bit, and I guess it would be good to use the flowmasters on my car. My dad recommended I get a muffler shop to put in duals, and maybe later try and replace the headers. Also, where I live there's no emission laws, so I might remove the cat (Or replace it with a very high flow cat)

[ExtrmZ]

i have heard a nice chambered muffler sounds great.. i really dont have anything on my car now..

if you plan to turbo your car, you are going to want to change your exhaust.. dont run any bigger than 2.25" on the N/A, and the turbo can go up to a 3"... so if you plan to turbo, dont get a whole new exhaust, its just a waste of money, there will be too much backpressure with the turbo on...

[LordLeverette]

Well, with the Flowmaster they have a 2.25" muffler, but what if I run them dual?

[mg man 75]

If plans are turbo. Check my exhaust clip in post of 1984 SVO exhaust.

[Mustanq]

Do you want just the muffler? I have the 40 series flowmaster, its great. A lot of people use them for their 2.3s. Get the 2.25 offset inlet/outlet. I'm not sure about duals. People say its bad since our engines need some backpressure. Other says it runs fine.

[ExtrmZ]

i would do the flowmaster 40, maybe a single inlet dual outlet, but thats as much dual as i would go..

[Green78II]

I have a headman header, 2 1/4" pipe, no cat and a flowtech warlock muffler.

YouTube - 1978 Ford Mustang II 2.3 startup, rev and walkaround

[Lowerednjuiced]

What I have: 1990 Mustang conv 2.3L turbo, 3" exhaust front to the Flowmaster muffler and right behind that a 4" wide by 8" long tip. No up and over the rear end pipe. It sounds like a 5.0 at idle to 3000RPM and then above that it sounds like a Subaru Impreza WRX turbo garbling. In front it sounds like its sucking up the concrete.

[Mustanq]

Hey I thought that flowmaster wasn't good for the turbo 2.3s? I'm looking for a setup on my 84 svo 2.3T but can't seem to find any that will make it have a nice growl..