[whcf150]

Hi, I am having a difficult time trying to rewire a svo engine. I have tried the service manuals as to what goes where. The color codes of the wiring do not match ANY of fmc diagrams. The engine is a 1984 SVO. I have completely rebuilt it. The wiring was burned and I removed a used harness from a 84 in a salvage. I checked the vin. to make sure it was the same. And they were. I attached all connectors and I have 6 wires left over that do not seem to go to any of the sensors. Example the distributor has a extra wire, RED and according to diagram the is not supposed to be. I also have a RED wire from a sensor in the block below the oil pressure and feed line to the turbo, which seems to be a coolant sensor. I also have another sensor under the intake, by the small coolant line, which I have no wire for it. I really need help in this. I have way too much money tied up to just give up. All assistance will be very welcome. Bill

[NavySVO]

PM me an email address and I will get you what I can.

There is the engine temp gage sensor in the block below the oil sender, and the one in the lower intake is the fan switch.

[whcf150]

Thanks for infromation, I hope I can locate what the other wires go to. I have a always hot at no. 1 plug and it is wrong color. (brown/yellow) Key hot is also incorrect,(green/yellow) All help is really appreciated Bill

[whcf150]

NavySVO, I failed to include my e-mail address crowder@gilanet.com.. Sorry about that. Bill

[NavySVO]

Bill, I got it, thanks.

Now, edit your post and remove your email address. Spammers will get it and you don't need that. That is why I asked for you to PM it. Outta site, outta mind.

I sent you an email.