ok use a breaker bar... the easy way is to lean the bar up against the driver side on the fender if possible then crank the motor for a sec and that will break the bolt loose... otherwise try it with the serp belt still on but i think it will slip still... i did the breaker bar way up against the fender and it worked... just put a rag down so it dont hurt nothing...
I'll def. do that when the lights out in the am. The crank position sensor is rusty from the water pump before I replaced the thermostat and gasket. How can you tell if it's bad?
well if ur car runs still the sensor is fine... lol... if its got rust on the inside where the magnet is u may wanna clean it with brake cleaner while its off... just make sure u take ur time so u dont break the sensor cuz they aint cheap... good luck!!!
well if ur car runs still the sensor is fine... lol... if its got rust on the inside where the magnet is u may wanna clean it with brake cleaner while its off... just make sure u take ur time so u dont break the sensor cuz they aint cheap... good luck!!!
That's the problem, It don't run. I'm trying to figure it out, but the timing belt was loose and dry rotted. Should the gears have play in them? It has play like a locked steering wheel.
timing belt help 
