does anyone know what tools to use or sockets to use to take the mid pipe cats off of the header, i got the sensors off, it's just those 4 bolts thats's conecting from the mid pipe to the header it's just hard to get in to and unbolt them
does anyone know what tools to use or sockets to use to take the mid pipe cats off of the header, i got the sensors off, it's just those 4 bolts thats's conecting from the mid pipe to the header it's just hard to get in to and unbolt them
Yea get some PB BLASTER penetration spray . Spray the bolts. Now you will need a long long extension for the socket and Ratchet to get up in there. You may need a wrench to hold the top bolt. Not hard to do. I am sorry I do not remember the sizes. I think 13 or 15 mm deep socket.
__________________
Airraid CAI/BAMA tune,moto blue pullies,3:73`s,LPW girdle;Powerhouse DS,CHE safety loop,CHE LCA`S & Adjustable UCA,Kooks LT`S & O/R X Pipe,prothane MM`s,Steeda CMDP`S,Eibach springs,Tokico D specs,Polished TB(by Me),Steeda radiator support,MT DR`S,Zex kit 100 shot. Taylor Relocation batter kit and cut off switch
11:933 ET, 1.674 60`,111.877 MPH 5600 feet above sea level 6900 D/A
ya, I actually had my hand lodged in between the cats and the motor somehow(just an hour ago, putting my new off road X and axle backs on)...ripped a bit of skin off getting it out. Its a B!*#$ to do. And ya its a 15mm deep socket. good luck!!!
__________________
'08 GT premium 5 spd-- TVS2300 tuned by Tillmans CR
My girlfriend calls it a waste of money, but I see it as saving money(and time away from her) if I install it myself
I built some ramps outta 2X10's. One set is 78" long on botton then 60" then 42" then 24" with a stop on the end. I back up on them then jack the front up and use jack stands. Gives you just enough roon to scoot around under. I did my LCA's and off road X using this method. It sucks but better than paying someone to do it.
__________________
'08 GT premium 5 spd-- TVS2300 tuned by Tillmans CR
My girlfriend calls it a waste of money, but I see it as saving money(and time away from her) if I install it myself
Installing an O/R h pipe question 
