The BBK instructions on their TB swap is to get the tps Voltage setting BEFORE you take the old one off and make sure it is the same when you install the new TB. They say the computer is very sensitive to this setting. If you do not know what the old setting was I would try moving the TPS within the normal voltage range. You might have to drill the screw holes a bit larger and grind off the locating tab. I had to do that when I changed TPS sensors after mine went bad. Sorry I am on the road and cant remember the normal votage range but its stated in the forum a bunch, so you should be able to search for it. Good Luck..GA
__________________ 05 GT Techco 7psi, 428hp/395tq, Tillman tune, 18x9.5 GT500 wheels, 14" Brembos, Steeda Front strut pads and front relo kit, BMR lowering springs, Tokicko D-Specs, GT500 Front lower control arms, BMR adj upper third link, BMR adj PHB, BMR rear relo brackets, boxed stock phb brace, Hooker super comp LT with Pypes HF cats, Stillen adj front & rear sway bars, Steeda sport shifter. | 
Need help with CAI and new throttle body 
