I have the Raptor shift light installed with factory tach Works well and install was pretty simple. It uses three wires: power, ground and signal(attaches to one coil wire.) The hardest part was getting the cable through the firewall. There is a rubber boot on the drivers side floor where I pushed mine through. See their website at:http://raptorperformance.com/
I did not know you could get just a light this is wonderful. I know it is just me but looking at the tack is a pain in the a$$ the steering wheel is in the way and when I am putting the pedal down the tach is the last thing I am looking for. I know I am old but I am not kidding you are holding own for all your worth.
__________________
07 GT. Exterior mods n/a. Engine mods, see profile.
One of the more powerful cars around.
One of the slower cars around.
Makes me feel like a kid every time.
I did not know you could get just a light this is wonderful. I know it is just me but looking at the tack is a pain in the a$$ the steering wheel is in the way and when I am putting the pedal down the tach is the last thing I am looking for. I know I am old but I am not kidding you are holding own for all your worth.
The raptor is small like a pen and has 2 white knobs to set shift points. the greatest thing yet for shift lights. No Tach to worry about and no Tach adaptors, Just tap into a coil pack, run a ground and a power and you're done.
__________________
10.308 @ 131 for now on a street car with A/C
NMRA #12015 SST
Looking for 9's on the stock motor before April-'09
The raptor is small like a pen and has 2 white knobs to set shift points. the greatest thing yet for shift lights. No Tach to worry about and no Tach adaptors, Just tap into a coil pack, run a ground and a power and you're done.
Hi Joe
guess Ill be talkin to ya again soon...I need a claw.
__________________
Saleen S/C 3.2 pulley tuned by JDM Engineering, GT500 pumps, CHE goodies on the rear, 4.10's, KOOKS/ high flow catted X pipe with PYPES Violators, Spydershaft, TCI 3500 stall, PA deep tranny pan. Meziere w/p,M&H 325/45/17 DRs.
future mods.... a 3.0 pulley
Yeah, noticed that in the sig. Track accident or street accident?
I keep looking at the Raptor, but I wish it was even less visible. I actually drew up a schematic for one that is similar, but uses a remote module you can tuck into the dash and a button-sized LED array. Theoretically, with the brightness of some of the new LEDs, a single LED could provide the same light as several older ones. Talk about easy to hide!
Now, I just need a chip burner and I'm a millionaire!
__________________
2005 Satin Silver GT 5spd, IUP, ICAP, bullits, active alarm, lug locks, side a!rbags, shaker 500, XM Roady 2, JLT cold air, Xcal2 w/ SCT 93 oct tune, & custom fab'd ram air duct, BMR Sway Bars, Hurst Competition plus shifter
Custom blackout on hood and trunk with Steeda street wing and Ford Racing hood pins
05 - Zeon body kit, Saleen S/C, 3.6" pully, 90mm MAF, L/T Heders, Catted X-Pipe, Saleen Race Craft suspension, Axel brace, Pan hard bar. More to come this spring from my friends at PMP and Larry H.
65 - Street force coil over front suspension, Wilwood disk breaks at all 4 wheels, More construction in progress! More to come this spring from Simons Auto & Restoration!
You can probably take the 'pen' apart and separate the parts... I did that with a radar detector back where they were illegal... sensor on the mirror and then extended all the wires for the rest under the dash with the screen 'hidden' under the stereo added an on/off switch for quick access too... with it all off nobody could find it nor know about it... pretty easy job...
On the shift lights, what if I wanna shift sooner 1-2 and 2-3? Maybe even 3-4 now with the gear?
__________________
KJ, poorer but happier
Thanks to: Modular Depot Fox Lake Racing Tunable Induction Power House 411 Sun Coast Creations
Yeah, noticed that in the sig. Track accident or street accident?
I keep looking at the Raptor, but I wish it was even less visible. I actually drew up a schematic for one that is similar, but uses a remote module you can tuck into the dash and a button-sized LED array. Theoretically, with the brightness of some of the new LEDs, a single LED could provide the same light as several older ones. Talk about easy to hide!
Now, I just need a chip burner and I'm a millionaire!
Street Accident, someone ran a red light and she hit them HARD!
Quote:
Originally Posted by zmanm3
Does SOS make a 3 gage pod with a raptor holder?
I know they make a 3 pod now, just don't know if it has a claw?
__________________
10.308 @ 131 for now on a street car with A/C
NMRA #12015 SST
Looking for 9's on the stock motor before April-'09
I personally run the Raptor as well as most of my customers. Small, Easy to install and easy to hide.
Hi DynoJoe, you mention easy to hide... does it attracts cops attention or it just for the sleeper effect...
Been thinking/needing one and for some reasons I would think that it might attract cops attention?
Cheers
__________________
'06 tungsten GT with pony package, CDC ducktail, MT, KB 2.6 I/C 9 psi, Centerforce DF, Shorty's, SLP Powerflow's, SOS pod / Cobalt fuel + boost, Steeda sport springs / bumpsteer kit / camber adjusters / G track brace, Tokico D spec, FRPP sway bar kit, BMR panhard/UCA, Spohn LCA's, Stop Tech stage 2, 18" 9/10 staggered chrome DD bullitts, KDW 2, Alpine/Ipod + JL Audio, 400+ rwhp/rwtq on 91 oct.
Shift Lights: Who Has Them? 
