If I push my clutch in with to much force, it kinda sounds like something is dropping in the transmission, or a clank noise. Ford fixed something similar to that a while ago for mine. I dont even remember what it was, it was so long ago, but If I push in the clutch with normal non-stressing pressure, it doesnt make the noise.....
Had the same problem, took it to the dealer they said they couldn't find or hear anything. (imagine that)
When I picked the car up the clutch pedal mechanism was covered with lube.
It's silent now....but I thought they couldn't find anything?
Just lube it yourself instead of having to deal with the dealer.
__________________
2007 GT/ GTA Mufflers/ Hurst Short throw/BMR Lwr & upper adj.control arms/ BMR Adj. panhard rod & brace/ Prothane motor mounts/FRPP 4.10 & LPW cover/ Steeda CMDP/Eibach suspension kit/BMR Lwr control arm brackets/ Powerhouse driveshaft with safety loop/ C&L Racer with SCT2 tuning by Brenspeed.
haha, im pretty sure my dealer did the same. They also said something about a lubing a clutch spring on my car? im not sure what that was, or how they did it, but it only took them like an hour. It made a difference whatever they did.
i had a slight squeak like that as well and had the dealership check it out during a tune up and it turned out there was a whole heep of clutch problems so you might wanna take it in and have them look at it...wouldn't hurt ya know
__________________
2005 mustang gt-mineral grey-5-speed -19" falken rims- XO vision Double Din 6.5" screen radio/dvd- Infinity Audio-FRPP 4.10's-JBA LT's, JBA o/r H-pipe, custom built axle-backs , Roush CAI (pre-Air raid), bbk 62 mm twin tb, hurst short throw, steeda UD pulleys, Bren speed 93-octane tune, SCT, BMR(anti-squats, 2" lowering springs, adj, panhard rod), Steed delete plates.
Future- Aluminum DS and full rear-end job, Fully upgraded suspension, brakes, cams, P&P heads, built engine, PH turbo.
i had a slight squeak like that as well and had the dealership check it out during a tune up and it turned out there was a whole heep of clutch problems so you might wanna take it in and have them look at it...wouldn't hurt ya know
Such as...?
__________________
C&L CAI with MAF, Steeda UP's, FR 4.10's, Predator "C&L-MAF" Tune, Borla 3" tip catbacks, Kooks LT/ Catted X-pipe, Nitto 255/45/18(F) 285/40/18(R), Steeda Springs, Tri-Ax, Adj Pan Hard, Camber plates, Cowel Hood, Tokico Adj Dampers.
dyno; 315 RWHP/ 320 RWTQ
2005+ Mustang With A Squeaky Clutch Pedal 
.gif "Scared")
