[epriii]

Does anyone know if you can buy the facia trim pieces that come with the FRPP exhuast separately? Or something similar?

[stlwagon]

Are you talking the little plastic pieces to cover where you need to make a bumper cut?

[epriii]

Yep. That's what I'm looking for.

[chopperman]

I couldn't find a place, dug high and low, even called Borla directly (was told they made the FRPP exhaust). Ended up buying the FRPP setup. Very pleased with it.

[epriii]

That's probably what I'm going to end up doing. Thanks for the recommendation.

[stlwagon]

AFM member FYouGitive has these installed.
2006 Mustang V6 Premium Convertible Black Pictures - 2006 Mustang V6 Premium Convertible Black Photos - Mustang Picture Gallery - AllFordMustangs.com

[FYouGitive]

Originally Posted by stlwagon

AFM member FYouGitive has these installed.
2006 Mustang V6 Premium Convertible Black Pictures - 2006 Mustang V6 Premium Convertible Black Photos - Mustang Picture Gallery - AllFordMustangs.com

Yes, I have. They are actually pretty substantial pieces of metal, sufficient, I think, to act as a heat sink to keep the body from burning when you get all hot with that exhaust.

I painted the screws black, too, so they don't look so erector-set-ish. Nice, but I still want that California Special rear bumper cover.

Also toying with the idea of put those inverted Lexus exhaust outlets in the V6 tailpiece.

[stlwagon]

Originally Posted by FYouGitive

Also toying with the idea of put those inverted Lexus exhaust outlets in the V6 tailpiece.

How would you do that?

[OSXFreak]

Ran across a Grabber Orange yesterday that had these on his rearend. I liked it, hence the reason I logged on this AM, wanted info on them. Well just got my GT take-off's and not looking to buy NEW kit just to get these covers, so I guess I'll wait for some smart vendor to start selling these as an aftermarket item.
Thanks for the info, and who said the internet was only good for porn..

[FYouGitive]

Quote:
Originally Posted by FYouGitive http://www.allfordmustangs.com/forum...s/viewpost.gif
Also toying with the idea of put those inverted Lexus exhaust outlets in the V6 tailpiece.

Originally Posted by stlwagon

How would you do that?

That's not a question I can answer yet. Don't have the information necessary, since I haven't found time or opportunity to crawl around under a Lexus to see how they do it. I see the bottom of the exits are a pretty close match for the V6 rear cover, but the face curve of the exit's exit would probably be opposite that of the bumper cover, since on the Lexus they are upside-down.

It's likely to be a mental exercise, anyway; I bet those Lexus pieces are a couple hundred dollars each, at least. I don't like the idea that much.