[bigman1418]

I was just wondering if i wanted to get dual exhaust for my mustang if i would have to buy a new rear bumper and get it painted or if i just had it cut out would it look ok?

anyone who has done this or seen this let me know how it looks plz.

[Thereaper]

Check out Newtakeoff.com.

[GrayPony]

Duals with rear cutout

[Rick Raymond]

All you need is a tape measure, blank piece of paper, Sharpe, new box knife, and fine sand-paper. 1.) Use the paper to make a template of the right factory exhaust cut-out, 2.) Measure true dead center of bumper, measure distance to r/h cut-out, then measure same distance to left side of bumper, place your template and mark radius with Sharpe. Cut, sand, you're done. Note picture of mine...

[waldo2824]

You can also get a template on the pypes website. That's what I used.

[stlwagon]

You can also use an old CD.

[billthecougnut]

I used the Pypes template, and a dremmel with a rotary cutting attachment, then finished the hole with some factory touch up paint. Took about 30 minutes.

[Mr. Ugly]

I traced the right side onto a piece of paper and used it to mark the left side. I trimmed the cutout with aviation snips. Didn't even need the dremel.

http://i17.photobucket.com/albums/b7...m3DSC_0052.jpg