C&L intake quick help!!!

venom800tt · 10-14-2008

Hey everyone i just received my C&L intake and it looks awesome, now i just need to wait for the SCT X3 to show up, already got the 91 Race tune from Doug as well in my email. So i was looking at the intake and this part confused me, does anyone know where to plug or what should i put on this 2 small holes, it is right beside and under the MAF sensor

hotshot · 10-14-2008

Does it attach to the heat shield? i have the JLT and i don't have anything like that on my intake.

sixers007h · 10-14-2008

That look likes what you actually connect to the MAF but not 100% sure. Show a picture of the entire CAI and I might be of more use

**pcfrisch** · 10-14-2008

Those have to be some sort of mounting holes since they are threaded. Do they go all the way through? Surely it came with instructions.

Vlad · 10-15-2008

It is not where you connect the MAF. That part is seen in the second picture. And I don't think it is to mount to the Heat Shield. The holes are parallel with the wall of the heat shield. I haven't a clue.

venom800tt · 10-15-2008

Yes it does come with instruction but it didnt say anything about this, I read the whole paper word by word. Anyone here running C&L on V6? Actually when i look inside the intake i dont see anything except the MAF hole. Maybe its something extra for other purposes, heres couple more pics

mikekimc · 10-15-2008

I believe that you should have recieved a mounting bracket and a bolt or two so that you can mount you're CAI to the right valve cover. You will have to remove a Valve cover bolt to mount the angle bracket and then to the cold air intake. Makes for a more ridgid installation.

Cheers
Mike

Turanza2 · 10-15-2008

Hey man I just put that kit in yesterday. The two holes on the bottom ARE in fact for the included mounting bracket. I didnt use it and it doesnt seem to have a negative impact. To be honest I couldnt even see a place that came close to lining up to bolt it too.

If you have anymore questions on the kit let me know

venom800tt · 10-15-2008

Quote:

Originally Posted by Turanza2

Hey man I just put that kit in yesterday. The two holes on the bottom ARE in fact for the included mounting bracket. I didnt use it and it doesnt seem to have a negative impact. To be honest I couldnt even see a place that came close to lining up to bolt it too.

If you have anymore questions on the kit let me know

Thanks a lot bro. Sure i'll let you know if i got to any problem. Wait im just going to jump to your thread regrading this lol

**stlwagon** · 10-15-2008

Use the bracket. The C&L is heavy and they sometimes come loose from the throttle body.

Turanza2 · 10-15-2008

Do you have a picture of where to mount the bracket to? Im new to all this but I couldnt find somewhere to attach it that it would reach to.

Mine also came with the wrong directions so I kind of had to guess a little (good thing its an easy install, lol)

**stlwagon** · 10-15-2008

Quote:

Originally Posted by Turanza2

Do you have a picture of where to mount the bracket to? Im new to all this but I couldnt find somewhere to attach it that it would reach to.

Mine also came with the wrong directions so I kind of had to guess a little (good thing its an easy install, lol)

Should mount to a valve cover bolt.

venom800tt · 10-15-2008

Yea if anyone have a picture would be great, i bought this from a member so it doesnt come with a bracket, it have everything showed on my previous post last picture. It would be really nice if anyone can get me and Turanza2 a picture of where to place it, its too far from the valve cover