I recently purchased some new projector headlights (they look amazing) and i was wondering if they are hard to install? Do i just pop out the old ones out and just put these in or is there more to it?
__________________
05 V6 Mustang SDS (San Diego Special) Only 200 made, i have #114. Current mods: 1/4 Window, Side and Rear Window louvers, 8' shorty antenna, silver stripes, CDC decklid trim panel, 18" Fanblade Rims, Eleanor Body Kit, C&L CAI w/ SCT Tuner, FRPP T-Lok, 4.10 Gears, GT Takeoff Sway Bars, and Ford Racing True Dual Exhaust
Still not done yet
Future Mods: black turn signals, Eibach Pro-Kit, Slotted Rotors and maybe a few more...
Ok first you have to take off the front bumper. This involves 6 screws and some pins. First you need to take off the radiator cover. There are 6 pins that pull out in the middle to release the cover. Then there are two bolts on top to release the top pillars of the bumper, and two screws on each side under the wheel wells. These can be accessed by removing the wheel well liner screws and peeling back the liner. Once that is done take off the bumper. There are 3 bolts on each headlight. Remove those to remove the headlights. Once that is done you need to seal your new headlights with RTV silicone to ensure that they do not leak. Once that is done you need to decide where you are going to wire your LED's, either parking lights or blinkers. Then cut and splice the LED wire into the choosen route. Once that is done plug the headlight harness into the cars reciever. Turn on lights to ensure that they work. After this step go ahead and aim the headlights. Once they are aimed, check all your work thus far. When you are satisfied of your progress put the bumper back on and enjoy the headlights. If you are not comfortable enough with any step involved in this process don't do it yourself.
__________________
2008 Dark Candy Red V6 Coupe, 18" SSE Wheels w/ Falken shoes,8" Shorty Antenna, SPEC Stage 1, Airraid CAI, 8.8 w/ 3.31, dual Vortech turbo exhaust, LED Projector Headlights, BBK shorty headers, SEIBON Carbon Fiber heat extractor hood, Sparco Hood Pins, Kenwood 7" touch screen nav/dvd, dos 8" rockford fosgate punch, SS window louvres, Midwest plenum cover, LED taillights, 93 race tune from bamachips, Personalized license plate "GOFASTR" (adds about 15 horses for the license plate) 220hp/232torq
Headlight Installation 
) and i was wondering if they are hard to install? Do i just pop out the old ones out and just put these in or is there more to it?
