Ford Mustang Forum banner

Codes galore!

1K views 3 replies 3 participants last post by  20sixxer05 
#1 ·
Alright guys so, i did the clutch in my car a couple days ago, clutch install went fine went with a luk clutch great performance so far. But about and hour after the install i had a check engine come on, and i have a ton of codes.
C0307
P0155
C0707
P0141
C0304
P0443
P0135
P0161
P0403.
These are what came up, my harness did get pinched, i pulled it out no breaks in any wires. So my questions is what could possibly have gone wrong? And is there a fuse for the 02 sensors? And lastly im doing a custom cat back so i cut the y pipe off would that cause this?
 
#3 ·
I can't tell from your post - what engine are you running? I'm just learning about this myself so I don't have all the answers, but you may need to do a crank shaft position relearn. This is done using Ford diagnostic software and so requires a trip to a dealer shop. It's my understanding that this relearn is necessary after clutch and/or flywheel work.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top