[Stars.Fade]

Alright, I installed my JBA H-pipe, JBA overaxle pipes, and a pair of beautiful shiny boomtubes....sounds great!

Inside the cabin...cannot hear squat...It's totally silent with abt 5% drone. Can't hear the exhaust with stero on 3.5 =]]]very happy about that


OOutside...it's loud, and very deep and makes an impression. When you step on it, it wakes up. At higher RPMS...4.5-6 it's badass. Has a race car sound...pretty cool

No complaints....just one problem

Im getting a rattle somewhere at 1.4-2k rpms....from the back. I think its where the boomtube clamos onto the overaxle pipe. Doesn't fit all the way and the clamp completes the seal.

Anyone else have this problem? thanks.

[amustangrocks]

doesnt fit up onto the tailpipe all the way? or around it? is the muffler clamp welded in place like the gt`s, you might be able to add one and double up the clamps.

[Stars.Fade]

Id have to purchase more clamps...and I even did already
I have 2 clamps...jusn't isn't quite long enough.
Probably will have to tack weld all the slip fit connections ...*shrug*

[amustangrocks]

ya, or pick up some small exaust pipe connectors and add a little more length to pipes. when i did mine, i didnt have one tailpipe all the way onto the h pipe and i tightened the clamps and crimped it good. i realized it too late. i got it off and tried a expander tool even, but couldnt get it as far on as it needed for clearance of the rear end so i cut about a inch off it. i actually had to cut a half inch off the over axle pipe on one side to get the muffler up farther too. exaust can be a pain in the butt