i just did this approximately a month ago and meant to take pics but didn't. as the post prior said, raise hood, remove bolts on either side of grill at top. then underneath, locate and d/c your turn signals. take out (4) bolts undernath on either side at the bracket where the turn signal lights are mounted. easier to do this with the front half of the splash shield off. then just very easily, remove the front bumper cover. if you are lucky, you wont have to drill the rivets out of the turn signal brackets which are part of the structure for holding the cover on. if you have to, then just replace them on the new bumper cover. re-install in reverse order being very careful not to scratch the bumper cover or fenders (a little blue painters masking tape will help a lot.) the old front inner fender liners can be used but it will look best if you get the GT specific liners and the GT bellypan with the attaching hardware. i got the belly pan, inner fender liners and hardware from KC @ clevenger ford. turned out really well.
__________________ "Thinking is the hardest work there is, which is the probable reason why so few engage in it." -Henry Ford | 
