[sixers007h]

When I put the gt front bumper on my car, the front of the splash shields were too short to connect with the tabs on the bottom of the gt bumper. Until now, its not been a problem, but I finally ordered a CDC chin spoiler so I figure I should fix the splash shield, which will also help sell the car. Do I just need to buy the splash shields from the gt from Ford or can I buy something that will allow the v6 set to work? Thanks for the help.

[sixers007h]

Any idea guys? I just got the chin spoiler in today, and I have to have something to connect it to.

[sixers007h]

Okay, I finally figured it out. The cars have a two piece inner fender, to switch to a gt front end, v6 drivers need to buy the front rubber inner fender from a gt, which comes from Ford for $37 a piece. The rear inner fender is the same on both v6 and gt models. I'll install probably Thursday, then install the chin spoiler.

[medic2586]

SORRY I DIDN'T SEE YOUR POST sooner but i recently did this with help from KC @ Clevenger Ford. Filler,Bellypan,Hardware,Wiring Kit if you are getting fogs, GT Splash Shields. These are the parts that i got from Kevin and my V-6 to GT nose-job came out perfect!!!