GTO Headlight covers install question Evenin all. This might not be the best spot for this but since it was not specific to the GT or V6 I wasn't sure where else to go. Anyway, here is what I would like to know......
I got the GTO smoked headlight covers a week or so ago and all I received in the box was the covers and an instruction sheet. I have to say the instruction sheet was a waste of paper. They tried to cover several different installs as generically as possible and it was pretty obvious that the instructions were written for the fox bodies and/or SN95s and hadn't been updated in long time.
How do these things install? I lifted the hood and the upper curled piece goes right into a pocket above the headlight. The rest around the sides and bottom kindof just snaps into what I believe to be the correct position but after I drive for a while the bottom and fender side pop out so you can see the little tab on the fender side of the cover. Do you use double sided tape on these or some other way to hold the bottom and fender side of the cover in tight? If so, I didn't receive any with the package.
Any direction/advice would be very helpful. Thanks!
__________________ 2008 Vapor Metallic GT Premium - 5 Spd, IUP, GTAP, Pypes Violators, 17" Aftermarket Wheels (Black/Polished), 8" Shorty Antenna, CDC Classic Chin Spoiler, Tinted Windows, GT500 Pedals, Pony Tri-bar Mats, CHE LCAs, Mag B-out Panel, GT Pony Dead Pedal, Smoked LED 3rd Brake Lt., Blkd-out turn sigs w/Stealth Bulbs, Projector HLs, Xenon 1/4 Window Lvrs, Splash Guards, |