[msbmustang]

Does anyone know how to remove the inside molding above the drivers side door?

Thanks

MSB Mustang / Mark

[bigwilly43729]

You are talking about the plastic on the interior, right? Just pop it out. You have to tug a little bit, but it should just come out.

[msbmustang]

Thanks bigwilly43729,

I will go out to the parking lot and give it a harder tug than I tried before. Trying to get a look at a vibration noise that is coming from that area!

Thanks again,

MSB Mustang / Mark

[HornyGT]

takin it out isn't the problem, getting it back in is, i had a hard time pluggin it back in. good luck

[msbmustang]

It does just pull out (a little difficult at the joint behind the driver however).

Sure enough there are lots of plastic bumps that are hitting the metal roof. I put in a lot of damping material over this areas of hard plastic hitting metal and another group of noises are now gone. Need to do the passenger side now and then back to the instrument panel.

Thanks everyone for the information it was a great help!

Mark / MSB Mustang