Do any of you fellow mustang owners know about the roush magpac rear exit exaust? If so is there also a rear exit roush bumper Im having trouble finding one so I dont think there is.
__________________
91 GT Hatchback- 3.73 Posi, Flowmaster O/R H pipe, Flowmaster 40 series mufflers, Tremec TKO, Pro 5.0 Shifter, Center Line 15s, Upper & Lower Control Arms,Weld-on Subframe Connectors, Eibach Lowering Springs
03 GT Coupe- Roush CAI and Jack Roush classic shifter, 40 series mufflers, Hooker Long Tube Headers, Hooker O/R X pipe, Custom Tune
I think your talking about Magnaflows right? No i dont think there is a roush rear bumper, only the front facia. But you dont need an aftermarket bumer for that exhaust.
__________________
-04 Mustang GT-Intercooled Kenne bell 2.1L supercharged @10psi, C&L cold air intake, mass air flow, Sumitt racing 75mm throttle body, Magnaflow catback with Bassani X-pipe, chip and dyno tuned, 3:73 gears, B&M short shifter, FMS lowering springs and UPR caster camber plates, UPR upper/lower control arms, UPR subframe connectors. Kumho 275 up front/Kumho XS 315 in rear. Currently 420RWHP/435lbtq
-Daily Driver 04 Toyota Tacoma PreRunner, Blacked out, TRD suspension, K&N filter.
I have the side exit with my roush body lit I love it but I dont think the plp next to me do when I get on it it gets real load lol but I used the flowmaster muffler with my set up tho love the sound of flows on a stang
__________________
2002 GT 5speed roush body kit with saleen s281 three piece rear wing totone black top red bottom fr500 nitto 555 275/35/18 with Eibach pro damper system BBK cai,BBK under drive pulleys,Headmen long tube headers,BBK off road X pipe,flowmaster 80 inlet and outlet same end so the roush side exit works,roush lower control arms roush sub frame connectors brenspeed x3 zex nos 125 shot hp257 tq295 on motor 380hp and 395tq on spray best 1/4 time now 12.770 at 115 with blowin the tires of in 2nd and 3d
Hmm, not too sure about that, but ya could egt the roush front facia and lower it, which is what i would do if i were you. The side exit exhaust would look good if the car was lowered.
__________________
-04 Mustang GT-Intercooled Kenne bell 2.1L supercharged @10psi, C&L cold air intake, mass air flow, Sumitt racing 75mm throttle body, Magnaflow catback with Bassani X-pipe, chip and dyno tuned, 3:73 gears, B&M short shifter, FMS lowering springs and UPR caster camber plates, UPR upper/lower control arms, UPR subframe connectors. Kumho 275 up front/Kumho XS 315 in rear. Currently 420RWHP/435lbtq
-Daily Driver 04 Toyota Tacoma PreRunner, Blacked out, TRD suspension, K&N filter.
Roush Magpac rear exit exhaust 
