i have the 2.1 non-intercooled kit,when i start it up when its cold their is a squickey noise,dont know if its the belt or the pulley,but when its warm it makes no noise anybody have an idea? other than that is runs very good.
__________________
03 MUSTANG GT,4R75W KENNE BELL 2.1 S/C NON-INTERCOOLED 6PSI
36LB INJECTORS,MONO CHIP,AUTOLITE 103s
BOOST-A-PUMP,SLP LOUDMOUTH CAT-BACK
TRICKFLOW 70MM THROTTLE BODY
STOCK AIR INTAKE WITH K&N DROP IN
FORD RACING 3.73 GEARS
are you sure its the S/C making the noise??? when was the oil in it changed last? i would say if you still have the stock belt then i would put it on bypassing the SC and let it idle and see if you still hear the noise. if you do then take the belt of completely and let it idle if the noise is gone you deff have an acessorie thats making the noise
__________________
MGW!!! Steeda adj clutch setup, Custom Exhaust (H), Diablo, motive (yes motive) 3.90s, steeda sfc's, steeda UCA&LCA, K&N FIPK2 Plenty to come
Garage: steeda long tubes & shorty x + TWS heads!!!
"Alcohol is for drinking, gas is for cleaning parts, and nitro is for racing!" - Big Daddy Don Garlits
the oil is a week old in it,i will try to listen more
__________________
03 MUSTANG GT,4R75W KENNE BELL 2.1 S/C NON-INTERCOOLED 6PSI
36LB INJECTORS,MONO CHIP,AUTOLITE 103s
BOOST-A-PUMP,SLP LOUDMOUTH CAT-BACK
TRICKFLOW 70MM THROTTLE BODY
STOCK AIR INTAKE WITH K&N DROP IN
FORD RACING 3.73 GEARS
dont think so but i will check it,whats wierd is i took that insulater from under the hood off then it started to make noise,cause the pulley was rubbing on it
__________________
03 MUSTANG GT,4R75W KENNE BELL 2.1 S/C NON-INTERCOOLED 6PSI
36LB INJECTORS,MONO CHIP,AUTOLITE 103s
BOOST-A-PUMP,SLP LOUDMOUTH CAT-BACK
TRICKFLOW 70MM THROTTLE BODY
STOCK AIR INTAKE WITH K&N DROP IN
FORD RACING 3.73 GEARS
That hunk of junk? Yeah, well I've made a few special modifications to that yellow 99 Gt, it makes the Kessel run in 12 parsecs and eats turbo japs and poops chevy's
it was rubbing on the insulater but i took that off,i dont see any rub marks on the hood, ah this sucks lol
__________________
03 MUSTANG GT,4R75W KENNE BELL 2.1 S/C NON-INTERCOOLED 6PSI
36LB INJECTORS,MONO CHIP,AUTOLITE 103s
BOOST-A-PUMP,SLP LOUDMOUTH CAT-BACK
TRICKFLOW 70MM THROTTLE BODY
STOCK AIR INTAKE WITH K&N DROP IN
FORD RACING 3.73 GEARS
I would bet $100 its your tensioner pulley...those seem to squeak alot with the added tension of a S/C....mine does the same thing squeaks when cold but once the engine warms up it goes away....either the tensioner or the idler pulley....but id bet money on that
__________________
1997 4.6 GT - Vortech V2/SQ Supercharger 12lbs, BBK Shorty Headers, O/R X-pipe, Flowmasters out the back, Cold air intake, 3.73 Rear end gears, T-Rex high pressure fuel pump.
you could always WD40 the bearings on your pullies and see if one of those is the culprit... i know my tensioner does this when its humid or wet out only when the engine is cold
__________________
MGW!!! Steeda adj clutch setup, Custom Exhaust (H), Diablo, motive (yes motive) 3.90s, steeda sfc's, steeda UCA&LCA, K&N FIPK2 Plenty to come
Garage: steeda long tubes & shorty x + TWS heads!!!
"Alcohol is for drinking, gas is for cleaning parts, and nitro is for racing!" - Big Daddy Don Garlits
03 MUSTANG GT,4R75W KENNE BELL 2.1 S/C NON-INTERCOOLED 6PSI
36LB INJECTORS,MONO CHIP,AUTOLITE 103s
BOOST-A-PUMP,SLP LOUDMOUTH CAT-BACK
TRICKFLOW 70MM THROTTLE BODY
STOCK AIR INTAKE WITH K&N DROP IN
FORD RACING 3.73 GEARS
Kenne bell problem!!!!! 
anybody have an idea? other than that is runs very good.
Plenty to come
