[00BLACKSTANG]

have 2 t-45 transmissions in my garage. I was wondering if any one knows how to check or test if they are in good condition with out installing in car? Transmissions are not install just by it self.
any help or advice will be great.

[05horse]

manual trans are simple....


turn input shaft 10 times count revolutions of outpus shaft in 1st gear then 3rd gear then 5th gear the more gear u give it the more outputs should come out.


just test it by hand turning it. drain fluiod. if its black replace it! i always fill my trans up on the ground when i got it out, saves 10 minutes of arm killing pumping.

[00BLACKSTANG]

I mean how to know if it has any worn parts like syncros or bearings. I spinned it with an impact drill @ 2500 rpm shiftted 1-5 gears and seem ok @ 2500 rpm the second t-45 spin it @ 2500 rpm and when shifting to 1 & 2 gear seems ok then 3rd,4th, & 5th gear the spinning started to get slower and harder to spin, while the other one was more smooth through all the gears.