Quote:
Originally Posted by 96redhotgt  One sensor sends a signal to your temp guage and the other tells the PCM what the temp of your engine is. |
If you have not installed your sensors yet, and your aluminum cross over channel only is only equipped with one hole for one sensor identified by the green circle in the picture provided. As mentioned in a previous thread, just install a nipple into that one hole, then install a "T" fitting on that nipple. You can then install the two sensors on both ends of the "T" fitting. This will eliminate the need for drilling the second hole identified by the red circle. Hope this helps. Good luck, Tommy.
http://i372.photobucket.com/albums/o...econdtappe.jpg
