[fresnoGT]

just a quick question about the steeda udp kit, are they hard to install? or do they just bolt on when the old ones come off?? i have an 02 GT 5 speed.

[fresnoGT]

does anyone know......

[Jokers97GT]

I just had them installed on my 97 GT 5 spd and they bolted on after the orginals were removed. You will need a puller to get the crank pulley off but other than that it was simple.

[dtorres03gt]

A puller???? hummm... Was it just like stuck on there or what because mine are in the mail right now. I thought you just unbolted the old and bolted the new.

[dollarbill]

You need a puller because the crank pulley is pressed and bolted on. Also an impact wrench is needed for the alt. pulley or else it will just spin when you go to remove it.

[fresnoGT]

thanks for the info...i have an impact but not a puller...how much did it cost for the install?

[FunkyBoss]

I got the tool at Advanced Autoparts for like $15. It's just a cheap Harmonic Balancer puller, but it does the job. Make sure you also have some high-temp silicon sealant.

[jjandascog]

silicon sealant

What is the sealent for?

[FunkyBoss]

It goes in the key slot on the crank pully.

[fresnoGT]

steeda says the pulleys bump up the gas milage is that true? if so does anyone know if its a significant amount