[htxfastlife]

im about to pull the engine to install some new heads with apr studs,tf intake,and i was wondering is there anything else that i should do to the stang while the motor is already out? im also adding new l/t headers and clutch.....any recommendations will be appreciated

thanks

[hotshot]

how about giving it a good solid cleaning while its out of the engine bay. Make it look nice and clean.

[bneher]

How about some Sick Nasty Cams in those heads? I went with the XE270 grind and they are pretty sick nasty sounding. If you want to check out a video that I have of my cams here they are

MySpaceTV Videos: Sick Nasty Camshafts by Brian

[Nicks79]

NICE!!!
Just remember to get everything off before you pull, because having stuff dangle is a bi**h

[410cougar]

hmmm would be a nice time to just rebuild it. order your self a forged rotating assembly and rebuild kit and youll be set for along time.


id definatly pull the pan and clean the inside of the motor along with the outside which will give you an idea of how its hanging in there. check cylinder wear as well as areas of excessive build up.

j

[dethwryder]

increase bore size,forged pistons, better crank, cast iron block. ****, stroke,and blow it.