[91fox347]

Will a fox body turbo system work on a 94 mustang gt. Will it clearance properly, any light modifications need to be done to make it work?

[DFINE160]

I have been told it will work but you have to do some fabrication because the 94-95 intake manifold inlet is kind of at an angle. I'll dig it up where I read it and post it here for you.

[DFINE160]

Here it is man, hope this helps. Goodluck with it.

the 94 95 has the throttle body on a slight angle torwards the passenger headlight, this set up has a 90 degree turn at the top for fox efi or a blowthru carb.
all that would hafta be done is the pressure pipe (inlet tube) would have an inch or two shaved off to mate with his throttle body.
__________________

[EagleAutosports]

You'd have to fabricate the piping to get it to match up but that's a given for a turbo install. The difference is the inlet like he pointed out.

[91fox347]

Thanks guys that helps out a lot

[DFINE160]

No problem man just glad I could help shed some light on the subject. Turbos are super sexy! I am going turbo with my coupe as well.

[2Manystangs]

If I was you I'd spend the money to stroke that 302 to 331, add some aluminum heads and exhaust and "hold on"! It will be scary fast...skip forced induction, it's expensive and the motor is not built for it.

[RLG34750]

With a little fabrication yes the turbo will work.....

BUT.....F/I on a stock bottom end is just asking for trouble

My suggestion would be go with strengthening the bottom end and a completed with H/C/I swap.....

Dial the car in & add the turbo later....

F/I injection should be used as a power adder not power substitute......