Hey everyone, I haven't been on in a few weeks, and now i got my computer back so here I am. I was putting in a new radiator yesterday when I I noticed that all of the bushings for my swat bar are pretty much non-existent. I am unsure of the size end links I will need as I had to cut through them to get them off. I am guessing between 4 and 4.5 inches. I also need the sway bar bushings with the mounts. I think i need the bushings to be 1.25 inches. I would like to know the best urethane bushings to go with, as well as if I am off on my measurements for a 1988 Mustang GT. Thanks in advance!
__________________
1988 red GT AOD. Mods: Ported GT40P Heads, 3-Angle Valve Job, E303 Cam, Edlebrock Performer 5.0 Intake, 65mm BBK EGR, Professional Products 65mm TB, MAC CAI, 80mm MAF, 24lb Injectors, 255lph Federal Mogul Fuel H.O. Fuel Pump, BBK Shorties, O/R H-pipe, Flowmasters, Dumps, Timing-16*, Shift kit, 4.10 gear, Sub-frames, Aluminum racing radiator, B&M Trans cooler, Pro-Form Upper and Lower Control Arms, Energy Suspension Urethane Suspension Components Recent: MSD 6AL Ignition, Battery Relocation
Energy Suspension makes good bushing kits, i have a few on my car. their frame bushing and end-link kits are available from summit racing, as well as a lot of other suppliers. btw, the end-link length for stock-height cars is 6 1/8". you'll need to measure the front sway bar with a calipers to determine its diameter, unless someone else on here comes up with it.
measurements for sway bar endlinks 
