[5.0mustangaod]

Just wondering what you guys think i should do next. Ive got a Mainly stock 5.0 Mustang. Im currently rebuilding the motor right now, but while its all apart what else should i do that would be a good cheap bolt on? Right now, everything is stock other than:

-E303 Cam
-BBK Headers
-BBK off road H-pipe
-Flowmaster cat back
-Fully rebuild T5 trans
-RAM HDX Clutch
-Steeda Tri-Ax Shifter
-3:73 gears
-MAF Convertion

[bdbolling19]

Looks like it's time for suspension mods.

[5.0mustangaod]

ohh yes! Ive got to put shocks on it, it rides like a brick sh** wagon there is hardly any recoil, then with low profile tires the ride is brutal

[StrokeYourPony]

Intake, injectors, fuel pump and MAF if you want more power. If you have not done it already tie up the frame and a strut tower brace will plant more power to the ground, ladder bars help a lot, no more wheel hop.

[5.0mustangaod]

i might do injectors :S i actually took the motor all apart to diagnose only 90PSI on piston number 8. Havent found the problem :S maybe a slight head gasket leak or intake gasket leak, anyways hopefully this rebuild will fix it

[StrokeYourPony]

Check the heads with a mini torch for cracks and the block surface as well.

[5.0mustangaod]

ive pressure washed it, and degreased it about 3 times. Its so clean its almost shiny but have had a master tech look at the block and heads and no signs of wear anywhere on the engine :P not even a slight sign of ring ridge. Engine had really good compression and i bought it off an older couple who only drove it to the grocery store and back.

[89mustang351w]

Alluminum heads like some tfs or afr's would boost the HP quite a bit!