[ramz28]

I am trying to remove my fenders to replace them but they just wont come out. Not like my saturn. Can any1 tell where all the bolts are that need to be taken out and any tips you can recomend. Should i replace bumper at the same time or can i do it after i do the fenders? and how do i know what the3 gaps are supposed to be on this car? 86 hatch

[redhotstang00]

If i'm right there 3 bolts on the top and two by the front inside of the fender and one right in the back on the bottom outside...

[ramz28]

ok ill have to try that and c how it works out. any idea on removing the front and rear bumpers i think its 20 rivets, each any way to reinstall with out rivets?

[redhotstang00]

The rear bumper have have nuts on them i think there 3 on each side of the car and the some on the middle you have to ge them from the trunk..

For the front you can take the whole from clip off there nut or bolt insidethe fender and maybe some on the front of the car... and if you want to take the bumper off you will have to drill out the rivets.. and to put a new one on your have to get some new rivets to install...

hope this help..

[ramz28]

it helps alot thanks

[Skinney]

I just removed and reinstalled the front clip on my 90 LX, both in pieces and as a single unit, I didn't have to remove any rivets, there are 3 bolts on each side on the top of the fender, one at the top back by the door, one under the fender back near the door, may be covered by a small plastic piece and some bolts on the front that keep the supports on. The front nose is bolted to the fender by 5 or 6 studs and nuts on each side and the bumper is fastened using nuts and studs through the rear sheet metal

[ramz28]

ill check it out over the weekend while i install my customed twin turbo hood