I picked up a built rear end off a buddy. Has 4 lug SSBC brake kit, 3.55 gears and auburn posi.
My question is since I'm upgrading the rear and it came with an SVO master cylinder and manual brake proportioning valve. I want to upgrade the front at the same time. I was going to go with SVO front calipers and good pads. Will I be able to reuse my current steel braided lines on the stock brakes? Will I have to grind or modify the spindles? Is there a write on the procedure?
I can't seem to find much online regarding a write up. Just forum posts without pictures.
My question is since I'm upgrading the rear and it came with an SVO master cylinder and manual brake proportioning valve. I want to upgrade the front at the same time. I was going to go with SVO front calipers and good pads. Will I be able to reuse my current steel braided lines on the stock brakes? Will I have to grind or modify the spindles? Is there a write on the procedure?
I can't seem to find much online regarding a write up. Just forum posts without pictures.