[steelers1377]

so how did you guys get your aftermarket shorty headers installed? i cant find any easy way to tighten the bolts that go onto the engine bc the tubing is bigger.... just wondering if you guys had any tricks... thanks

[Pro Mustang]

I use long 1/2" dive extentions. You need about 10 to 12 inches to get the ratchet below the exhaust pipes. Then it is easy!!

[steelers1377]

you bolted them both up from the bottom of the car i gues??

[wayne94mustang]

your not using the stock bolts are you?

with normal aftermarket header bolts its not bad at all.

[steelers1377]

ha i was using stock bolts.... picked up some header bolts from my firends motor builder for free.... problem solved.