 HCI Install Question.
I have my motor partially stripped down now. Next off are the accessories, headers, then the heads (intake is off).
So I would like any suggestions you might have on dealing with the accessories. Like, is there any way to get around pulling the power steering pulley? Can I pull the power steering and AC compressor aside as one unit by just removing them at the bracket? Any other suggestions for dealing with this side of the engine? And what about the alternator, balancer, water pump? I am pretty sure all that needs to come of too.
Thanks for the help. (I love my PB Blaster bottle right now!!)
__________________ Current Mods: FRPP 4.10 gears, MGW shifter, MM sub. conn., Am. Th. cat back, K&N, Miglia wheels, wheel spacers (1 3/16" rear).
(basically stock)
Soon to be installed: Street Heat intake, Twisted Wedge heads, Anderson Ford B-31 cam, BBK LT headers, BBK mid pipe w/ cats, BBK 75mm throttle body, AFM power pipe, Pro M-80 MAF, FRPP 30 lb. injectors, BBK 255 lb./hr. fuel pump, H&R race springs, Bilstein shocks/struts, FRPP FR500 steering wheel.
(not so stock) | 
