View Full Version : Classic Tech



  1. 1967 Mustang Rear Window Top Center Chrome Removal
  2. correct distributor for 289 2v mustang
  3. 1967 Mustang brake swap
  4. Hey guys could use some help
  5. 1967 mustang front drums and rear end swap
  6. 1969 Mustang drums to disc,If i use a doner car which car will work?
  7. Round(?) wheels
  8. Paint markings on 64 1/2 coil springs?
  9. 1968 Mustang Coupe: Valve Cover Crud Question
  10. 1966 Mustang with 1986 EFI engine, Valve cover question?
  11. 1969 Mustang Coupe paint and primer questions
  12. 1968 Mustang Choke Tube Cover Melting!
  13. Restoring 1968 mustang center console
  14. 351w engine build help
  15. Mallory Ignition factory tach
  16. 1967 Mustang 289 Thoughts on Torques
  17. master cylinder removal
  18. 1965 Mustang Heater box assy?
  19. preparing for an 8.8 rear
  20. Looking for an HEI distributor
  21. Is anyone running the torq-thrust type m Shelby wheels?I wanna see pics if u are.
  22. 1970 engine, transmission etc. tags
  23. 1966 Mustang 351 Windsor Cam for Low end Performance
  24. painting dash and doors
  25. 1966 Mustang... from Sprint 200 to a 302
  26. '68 302 Distributor wiring.
  27. need 4barrel Holly carb inf.
  28. complete interior for a 1967 Coupe
  29. To rebuild or not to rebuild?
  30. 1965 Mustang Alternator harness
  31. 1965 289 oil cap ID
  32. Wet Sanding as a preparation for painting
  33. 1966 Mustang dies when running like no fuel.
  34. 1968 Mustang - center dash panel install
  35. 1967 Mustang instrument panel wiring pics
  36. Vibration stating ar 1800 rpm?
  37. Installing stereo in 1965 Mustang glovebox
  38. Cam replacement in a "70" 302 question?
  39. Painting 67 fastback help
  40. The Best 1967 GT500 Shelby Fiberglass Kit?
  41. 1966 289 Header help ????
  42. Be thankful of our friends here
  43. 1966 Mustang High Beam Issue
  44. 1967 mustang rocker arms
  45. 1969 Mustang, another wheel question. Thanks
  46. 1967 289 - Holley 600CFM "Traditional" vs 570CFM Avenger
  47. Starting problems with 1970 Mach 1
  48. How do you remove a 66 headlight switch?
  49. 1965 Mustang, is the yoke the same for manual and automatic transmissions?
  50. Can anyone tell me what a revision number is?
  51. which motor 302 or 351
  52. 1968 Ford Mustang Rear End
  53. holley carb accelerator pump
  54. 1965 Mustang coupe, Rusted Out Battery Compartment
  55. Front Race Apron for 1965 Mustang
  56. Alert! Dumb question about 302 engines
  57. 68 302 Front timing chain cover seal...which was does it go into the cover?
  58. 1967 Racing Dash?
  59. No exterior lights work on 66 mustang
  60. Oil pan gasket torque settings?
  61. 1969 mustang coupe rearend help
  62. New to site and Mustangs, have a question already
  63. 1966 Mustang Timing chain cause engine not to start?
  64. Can i use 1970 Galaxie disk brakes on my 1969 mustang?
  65. Radio Suppression Condensor 65 6-cyl
  66. 1965 coil springs for non-mustang
  67. Strut Rod Bushings
  68. 1973 shock tower question
  69. Do 289 Crankshaft and rods have value?
  70. Mystery Washer from a 289?
  71. 1972 Mustang Grande 351 Cleveland
  72. 1972 Mustang Grande 351 Cleveland
  73. Correct appearence of fender bolts for 1964 1/2 Mustang.
  74. Paint markings on front suspension for 1964 1/2 Mustang
  75. power steering removal 1966 mustang