- engine placement in 1965 mustang
- lights dim at idle and are bright at high rpm?
- 289 horsepower Upgrade help
- 1968 mustang coupe brake light issue
- 1971 302 compression ratio
- Real stats for 200ci?
- 1966 Mustang Has Rust Bubble
- 1 3/4" headers with Steeroids R&P
- coil voltage question related tp Pertronix
- '66 200CI carb selection
- 1967 200c.i.d. C4 to 3-Speed Swap, need help.
- 1966 mustang starter problems
- 1968 Mustang electrical problems?
- 289 engine rebuild
- Flickering gauge lights at freeway speeds
- restoration guide book suggestions?
- road worthy, rust bucket, or refurbished body
- Engine smoking and using oil
- What is needed to make over 500 hp out of a 428 FE?
- Flickering lights
- floor pan replacement, 1966 coupe.
- 1964.5 Mustang Brake Light Switch Help
- affectivness of a carb spacer ???
- another carpet question.
- Help with color combination
- 1966 Mustang interior paint codes
- 1967 200ci rear main seal
- How much of the convertible top is supposed to be showing when fully retracted on a 1
- New Member - 1968 Mustang Timing Pointer
- Car Cover/Antenna Conundrum
- Led gauge bulbs
- Help finding 'balance' problem
- no brake pressure
- 1966w/ 302.Performance header selection help?
- accelerator linkage
- engine belt for smog system
- 289 With No Compression
- 1966 amp and temp gauge
- A great exhaust manifold gasket
- 1966 mustang amp & temp gauge
- 68 mustang stutters on takeoff
- c4 transmission
- 66 coupe window felt install question
- blew 2 CVR's for Gauges, with a 3rd all works now ammeter is reading low/high
- I've checked the classified section
- Adjustments on windows; trim piece?
- Cables and Pistons 1988 Mustang LX
- Trim ID please: 1966 Mustang convertible
- 1966 Mustang front disc conversion
- 1965 Mustang FastBack vent hack into Shelby plexiglass
- 1966 intake manifold torque specs?
- 1968 Mustang-fuel overflow while filling
- 2V Accelerating Pump rod adjustment
- 1966 Mustag convertible power top conversion?
- 1967 Mustang Exhaust?
- Seeking correct v-belt help
- Where to get exhaust flange donut kit.
- 1969 Mustang Power Steering Leaks...How difficult to repair?
- 1966 Mustang Wiring Diagram
- 302 With 289 heads?
- engine for a 67 fastback
- 1965 Mustang-I don't have rear seat belt mounts, do I? PICTURES
- How do i remove the rocker trim mount on a 1969 mustang?
- petronix ignition wire
- help with my new carpet.
- 1969 door bolts some short some a little longer
- adjusting timing w/vacuum guage?
- 1969 Mustang Break Booster?
- Upgrading my 67 i6, Keep my 4-lug or go 5-lug for Disk brakes
- Granada swap in a 67 mustang
- 1966 Mustang-Adjusting door position. Correct gaps.
- Which Battery Tray do I need?
- door light wire harness on 1966 Mustang
- need advise on outside mirror screw & fastner
- 1967 Mustang overheating issue (about out of options)