- Good news for '66 clutch
- Cable clutch on a 66 w/ a 3-speed
- My brake lights dont work
- Electronic Ignition Question...
- The best sounding exhaust for a classic mustang
- Spark plug type and reccomendation.
- Help removing rear drum
- Help Needed Alternator wireing question
- Looking at Stroker Kits...Need more information.
- Quick and easy 289/302 question
- Need help 5.0 efi in a 66 Stang.
- Need printed circuit for mach dash
- rear lift leafsprings
- New to forums, problem with left front frame rail, 67' 289 Coupe
- Confusing Casting numbers
- Performance rods for 289's
- Need Piston Ring Help!!!
- Whats causing ticking noises in 351 Windsor engine in my 79 Mustang?
- Newbie with an engine question.
- New to the forum. Question on brakes
- Autolite 1100 carb
- GT40P cast heads
- Identifying my Edelbrock carb
- 66' mustang tachameter help
- Need help in my quest for a 65-68 mustang!
- How do i know if i have a factory dual exhaust?
- 1968 brake upgrade
- Radiator hose?
- rear suspension ?'s
- Rebuild a Brake proportioning valve
- Matching Seat Sizes?
- is diff compatible
- motor mount brackets
- Rear-end help
- Size is an issue!
- how much can i sell my car for?
- I have been reading too much and now have some C4 tranny question
- wheel question? Will I need spacers?
- What is the difference between a 351W and 351C?
- Removing Vinyl Top on 66C
- air pump performance
- Bolt-on vs. stroker
- 302 or 390
- fitting colsole for ac car
- New clutch for 66 mustang HELP!!!
- Just got myself a 289, got some questions
- Popping Noise
- interior help
- '71-'73 Tach diameter?
- removing wiper and headlights bezel
- Help! Should i keep or sell my stang!
- Power Steering Removal
- Do they fit?
- Are all rally wheels made by the same company?
- Insturment Cluster lighting problem
- Flexplate Wanted Immediately
- Traction-Bars for a 69*Suggestions*Which ones?*
- rear disk brake conversion
- Brake Booster
- Rebuilding a 260, recommended tools
- 67' GTA Trim
- Edelbrock intake question. (dumb question)
- T5 swaping : Centerforce Flywheel & Clutch (HELP)
- Do I need inside rocker panels?
- Do I need to replace self-adjusting brake?
- 289 Engine Question
- going from C-4 to C-6??? Got a few ?s
- Help with carb
- 66 Gt Rack & Pinion <need Help>
- What size rims and tires?
- 1971 mach1 headlight problems
- any info on a 1967 GT coupe?
- 351W intoa 65 Fastback
- Gas Tank
- Replacing bushings on sway bar?