View Full Version : Classic Tech
- Headers...good or bad?
- Fire and Brimstone under the Hood...
- Help 3 or 4 bolts????????
- drilling holes in thermostat
- EFI 5.0 intake on 289
- 66 rear seat delete?
- Help choosing headers please
- thermostat have a gasket?
- I'm having issues with wheel spin.. ...
- found 351 is it worth it?
- Brand New Demon Carb, but isnt getting enought gas when wide open?
- Ford Mustang 1969 HELP!!!!
- car overheats and wont start?
- Carburetor and Intake Replacement
- engine over heating need help think its thermostat
- 65 Headlight Switch Trick?
- Gas mileage question.
- Spring on seat tracks
- install of ignition key
- Will a 428 Police Intercepter Intake Manifold fit on my 390 engine?
- fuel cell
- Restoration Needed, help locating shop in Fl.
- Factory ignition coil placement
- Ford T-10??
- Need advice on some frame-work..
- 68 GT 390 Suspensions, need some ideas
- New Clutch Advice
- Carb question
- 71 rod info
- What head gasket to use on a 1969 302?
- Hi-po 289
- 302 heads??? How do I decode them ??
- Out Of The Ordanary
- 65 stang water pump?
- Transmission Vacuum Lines/Hookup
- 5.0 swap?
- 351c headers 4sp what type?
- 72 Mach 1 w/351 Cleveland --- Paint, Decal, Sticker, Emblem location and measurments
- 69 428 CJ Rearend and exhaust system
- 351W into 66? fit or not?
- heating problems 69 mach one 351W
- Rocker arm nut ?'s, need info on keeping them tight
- Restore and update a 1965 Mustang Coupe
- Muscle Parts Intake, need more info on intake
- What is the cranking PSI for a stock 1969 302 engine?
- Which side does which track go on(seats)?
- 1969 Round Dash Clock - What's the Green Hand for?
- broken rocker stud
- mustnag 2 front end into 66 coupe
- 68 302 parts that will fit a roller5.0 block
- Need help hooking up carb on my 69 Mustang
- 289 or 351w / 425 Horsepower
- Dizzy Question -How much advance
- Stock Question on '65
- Ford V8 timing settings
- starter swap, late model on a classic?
- Persistent Front End Squeak
- I want to change from drums to disks on my 1971 Mustang
- Problem with Clutch Release Rod
- Engine 1/2 Power HELP
- Boss 460?
- Hood pins
- carb question and oil leak question
- how i can identify a 351c , 351W
- Mufflers Suggestions
- Stuck 1966 Gas Cap - Help!
- anyone know about the convertible hardtop kit for the 65-68's?
- Can I put a newer 5.0L and IRS into my 1965 Mustang?
- Power Steering Pump problem?
- Idle problem with 87' 302 EFI
- Info on jetting a carb
- 289 or 302?
- 9" Differential Houseing
- How HOT does it get in the engine compartment?
- How to Identify what year 351-C
|