View Full Version : 5.0L Tech



  1. 1994 Mustang GT bad idle and Lean Bank 1 question
  2. need to know if these headers will fit w/ aode
  3. RMI-25 cooling system flush ?
  4. steelers1377 - motor/car build thread
  5. 1991 Mustang fuses, 10 wrong, worried.
  6. 1989 Mustang convertible 5.0 front coilover install
  7. Ignition lock cylinder in a 1995 Mustang
  8. 1992 Mustang GT 5.0 Valve Adjustment proper procedure
  9. Does a t-5 fit a 2.3l?
  10. Question about heads
  11. Replace flywheel along with clutch assembly?
  12. Use Cobra Intake and Gt40 Heads to there potential
  13. 1988 Mustang GT 3g install and STILL low voltage?
  14. new motor with J302 heads
  15. Front clip exhange..
  16. BBK long tubes not fitting AOD
  17. 1987 Mustang GT-starter problem HELP
  18. rubbing or slight grinding noise???
  19. 1993 Mustang LX 5.0HO check oil light
  20. New Exhuast For 1980 COBRA (302-5spd)
  21. need help please
  22. 1989 Mustang GT running rough occasionally
  23. 1989 Mustang GT oil pump Install help
  24. FMU calibration
  25. starter sticking
  26. EFI to Carb Question
  27. anyone running a 351w bored .060 on the street?
  28. buying a rebuilt motor from a 1993?
  29. 1986 Mustang Fuel pump replacement cost?
  30. oil pump driveshaft help
  31. 5.0 builup for my Jeep
  32. One Wire Procomp Distributor
  33. help with torque specs for head studs
  34. 5.0 Truck intake lower swap?
  35. 1991 Mustang turn signal and reverse light problems.
  36. 1991 v8 Mustang speedometer problems
  37. How/where to install 1991 Mustang T5 Clutch Cable?
  38. need help with F303 cam. 1988 Mustang 5.0
  39. 1992 mustang crossover tube plugged
  40. Next addition???
  41. Motor out and in now clutch super stiff. Wife is making me sell if can't fix
  42. 347 and 150 shot nitrous
  43. Intermittent electrical problem
  44. 1993 Mustang 5.0 started shaking BAD!
  45. 1989 Mustang 4-cylinder to 8-cylinder conversion
  46. 1986 Mustang GT, factory amp bypass
  47. Exhaust Question
  48. 1986 Mustang GT cooling problem
  49. Rear Main Leaks...
  50. injector harness
  51. Trick flow or Edelbrock?
  52. Well, the 1990 Mustang GT caught fire today!
  53. 94 mustang gt 5.0 HO idle problem !
  54. 1981 Mustang to 1991 Mustang front end conversion
  55. maf question
  56. sn95 to foxbody Intake Swap
  57. 1990 Mustang GT T56 swap
  58. how much horse power do headers and hi flow exhaust give you
  59. does H/C/I require MAF swap?
  60. New Member with 1988 Mustang GT
  61. ford racing headers with gt40p heads (WIIL IT WORK)
  62. Differential support?
  63. tips on buying used engine
  64. I need a A9L for a 1993 Mustang GT
  65. 1989 Mustang GT, broken water pump stud
  66. 1982 Mustang 5.0 to efi conversion
  67. speedometer gear for 3.73's ???
  68. want to run 275/50 DR's on my spare turbines
  69. 1983 Mustang GT -- Opinions on engine swap/rebuild
  70. Intake swap, won't idle, runs only when pumping the gas, misfire, etc
  71. 1991 mustang procomp heads
  72. Fuel Pump Question
  73. new Distributor in with Issues?
  74. throttle position sensor
  75. What is the difference between a 302 in my 1982 Mustang ?