View Full Version : 5.0L Tech



  1. upper hose feel hard (under pressure) is that normal? please help
  2. Did this performance shop just mess me over?
  3. Need help with Mechanical Oil Pressure and Water Temp Install
  4. In desperate need of some help with my 1988 Mustang.
  5. Whats my HP/TQ ??
  6. head bolts torque
  7. 1991 Mustang GT-Fuel pump relay not working Help!
  8. Yes, another post about HEADS.
  9. Will synthetic oil decrease smoke?...
  10. will Mustang lx doors fit gt foxbody?
  11. K member for my 1990 lx Mustang
  12. Go SPOUT resister!
  13. 1991 Mustang GT, what's the best suspension
  14. 1991 Mustang GT with T-5 nitrous shifter knob, problem
  15. Will 1988 E7 heads bolt to 1969 block?
  16. All four corners
  17. How much horsepower do I really have?
  18. valve spring install on gt40 heads
  19. 94 gt, engines out, what to look over/checkout?
  20. 351w strange block casting number
  21. Eagle Rods for 347 Build
  22. nitrous on stock engine
  23. 1989 Mustang, weight reduction in fox body doors
  24. Question about stock Fuel injectors
  25. 1995 gt erratic idle and erratic power loss durring acceleration?
  26. 1987 Mustang GT AOD ?
  27. gt 40 heads question
  28. BOGS a little under initial throttle
  29. 5.0 idles fine but once it is out on the road loses power
  30. 1987-1993 Mustang door contours
  31. Car overheats only when I use the A/C
  32. tps sensor issues
  33. Running ultra rich when hot issue on 1989 Mustang GT
  34. 1989 mustang wiring harness help
  35. mass air flow ?..
  36. Timing question ?
  37. How do I test air/fuel mixture? What do I need?
  38. 1993 fog light covers
  39. 1989 Mustang Gt Backfires then Dies.
  40. 1989 Mustang sensor problem
  41. 1988 Mustang LX-bad filler neck gromet
  42. 331 Stroker build up for Carburtor
  43. Is it ok to run the car without the serpetine belt sytem
  44. Oil Pressure on rebuilt 306
  45. How does the 1993 Mustang Computer Adapt to Mods?
  46. Best way to clean MAF and IAC sensor?
  47. T5 to TKO600 swap
  48. 1996 explorer 5.0 swap in a 1990 Mustang gt--need advise
  49. No start after all wiring harnesses changed?
  50. 1987 Mustang-low oil pressure problem
  51. T5 Transmission Backup Light Switch -- HELP
  52. scanner wouldn't reed my car?
  53. transmission swap from 1992 T5 to 2000 model 3.8 T5
  54. where to start with 1997 explorer motor
  55. 1991 Mustang GT-Bad Ground Instrument Cluster
  56. Need help charging A/C on 1990 Mustang 5.0
  57. It"s too hot up here "help"
  58. 1988 Mustang GT Hatchback won't start.
  59. will stock crank/rods hold up on a 1993 Mustang cobra with a vortech v1 at 10 pounds?
  60. Uhhh, My car just back fired!
  61. 1990 Ford LX 5.0-Starving for Fuel
  62. opinion on these Melling pushrods
  63. oil in the coolant
  64. help with steeda #19 cam install
  65. mileage counter help
  66. Power Steering issue when car is off.
  67. Can anyone find a 5.8L (351W) crate engine?
  68. Plug IAC? Need Input...
  69. any comments of suggestion please!!!
  70. Help on tranny crossmember
  71. Start problem 1991 Mustang
  72. Heads: D80E vs E7TE
  73. 1990 Mustang steering wheel wiring
  74. 1991 Mustang GT Rear wheel seal/ axle bearing
  75. Master Cylinder Bleeding