- Cats glowing bright red after engine transplant
- went from 19-20mpg down to 14.5
- just how bad are factory Fox Body brakes?
- cam clearence question
- Anything special bout a 1968 DZ 302 block?
- 1989 mustang gt wheel bearing question
- 1993 Mustang 5.0 LX miss fire 6 clyinder
- head gasket question
- stering wheel problems
- how do I get fog lights to operate independently? 1988 Mustang GT
- Hard to get in 3rg gear under load
- Brake Caliper Bolt ?
- How To Replace Wheel Studs.
- 1990 Mustang gt brake light switch help
- e7te valve seals?
- msd problems !!!
- 1979 Ford F150 vacuum problems
- Gauges not working properly on 1986 Mustang
- Weird idle 1987 Mustang 5.0
- 1989 mustang tps ref voltage
- Oil on top of manifold problem
- power steering pump noise
- 351w swapped in 1986 Mustang
- T5 1988 Mustang GT HELP! no spark no fuel!
- Fuel or spark issue, idont know? HELP
- 1992 5.0 Mustang hesitation! Need help!
- taking my A/c compressor out
- 351 windosor heads swap, want big power
- what size cam for gt40 cast heads
- HP estimate anyone?
- What size injectors ? For kenne bell supercharger
- carbed 351w swap questions
- installing my 302
- old gas in tank
- 88 2.3 to a 5.0...How Hard?
- Wiring harness issue after 4 cyl to 5.0 swap
- new to forum, have a few questions
- compression test results
- Transmission mounts and vibrations at highway speeds
- Leaking Anti-Freeze
- Why is my steering loose?
- TFS 2 Cam
- Walker dyonmax cat back exhaust
- 1989 5.0 shuts down when hot, starts again when rested
- 1992 5.0 Mustang not starting
- master cylinder wont seal, 1989 Mustang 5.0
- looking to buy motors, help on what to look for?
- Master cylinder vaccum noise
- Questions about this stall PDQ F47
- 1995 Mustang GT 2nd post to question
- 1989 Mustang Notch 5.0 Gears?
- Need help....Name this Part
- tranny help wont let me go in reverse
- Brake Distribution Problem
- all gears work fine but no reverse???
- Smog Pump Delete, 1995 Mustang GT
- Can I change from Flat top to dome with out problems?
- 1993 Mustang accessory bracket torque?
- what kind of Timing gun
- HELP-Locked out timing-vs-Spout connector-HELP.
- 1990 mustang 130 AMP Alt upgrade
- 1991 Mustang GT - Lost Third Gear, Just Grinds?
- 1988 Mustang 5.0 installing a E303 cam?
- engine spins and spins
- proform ignition, opinions?
- 1989 Mustang GT-I need some help with engine vacuum Lines
- ecu question...
- Wheel spacers why?
- Installing Summit(6al type) box on my 86' wiring not going well
- Took it for a ride with it gutted
- Question about setting timing
- Over Tightening Clutch
- Converting a 1988 mustang 5.0 from automatic to five speed
- Fox Body Clutch Cable Adjustment?
- Torker 2 intake manifold