PDA

View Full Version : 5.0L Tech

  1. engine hesitation
  2. 1993 distributor cap direction?
  3. Engine Stand bolts.
  4. Air conditioner question on 90 GT
  5. Help! 93 5.0 Alternator belt tension
  6. edelbrock RPM xt ?
  7. HELP (Pollution Control Sensor) HELP
  8. Headers for GT40p cylinder heads on 89 Notch.
  9. Which comes first?
  10. GT40p Heads to trickflow manifold.
  11. The last half inch of the pedal
  12. 331 stroker cranking issues
  13. Relocating the alternator to the driver side?
  14. I think I fried the electrical!
  15. Please look at this pick and tell me what goes where.
  16. grey smoke under full load
  17. Need New convertible top for 1989
  18. Electrical and Hood problems 1991 5.0
  19. 1989 - video of motor chirping and crank case pressure
  20. Help-Installing auto meter A/F ratio Gauge
  21. pix inside Need help finding proper location of grounds and wires.
  22. motor swap 86 and 85
  23. C4 Rebuild Suggestions or Advice needed
  24. After market manifolds to heads.
  25. 1988 Mustang GT MAF conversion Questions
  26. 93 cobra motor surges
  27. 1988 Mustang GT engine troubles
  28. What alternator can i get for my 86?
  29. 351 and carb questions
  30. 89 GT, Electric Fan question
  31. Where to buy EEC pins? (For MAF conversion)
  32. compression for an 1988 5.0 w/ less than a 100k?
  33. Alternator Issue
  34. maf question.....
  35. Help me on wiring this thing! Reggie!
  36. my 1987 gt mustang 5.0 makes a popping sound?
  37. Dyno reveals misfire at 3300 rpm
  38. how to adjust the fuel pressure regulator?
  39. 5.0 Frankenstang
  40. which computer to use in 88 gt mustang 347
  41. Several Problems, please help!
  42. Floo Tek 5.0 X Heads by Tri-State
  43. Head problems
  44. Rebuild with low $?
  45. 351w maybe switch to roller cam
  46. 1991 mustang lx rebuild help
  47. Trick Flow Top End Kit
  48. what is the correct drive shaft length 89 mustang
  49. tri state cylinder heads> worth the cash?
  50. roller rockers for gt40p heads
  51. 1989 mustang rear control arms help
  52. 86 GT misses at low rpms
  53. Which trick flow manifolds?
  54. Steeda superlite drag springs
  55. flywheel information
  56. i need cam help!
  57. Is it worth installing a rear complete control arm kit?
  58. Power loss reasons
  59. 92 mustang no injector pulse
  60. 88 GT problems starting when it rains.
  61. Does a CAM effect brakes
  62. throttle body studs rusted
  63. How many cfm for eletric fan on a 5.0l
  64. Mustang 5.0 1988 Problems please help
  65. Which Dizzy for Carb swap?
  66. 1995 shorty header questions
  67. 1995 Convertible top switch bypass
  68. eecIV pin 46 short
  69. Changing head gaskets
  70. 1985 mustang GT Headers
  71. shifting problems!
  72. Reading and programming EEC RAM
  73. Sudden shuddering can't figure it out.
  74. Need Help Squeel is driving me nuts
  75. R&R Magnetic pickup in Distributor