PDA

View Full Version : 5.0L Tech

  1. t-5 transmission is messing up
  2. 1989 Mustang GT: Help please with springs and ride height
  3. Suggetions for comp cam with afr 165 heads
  4. Engine Internals question(s) Forged or Cast [advice & opinions needed]
  5. 1993 Mustang 5.0 missfiring while accelerating
  6. 5.0 vs 4.6 Pros & Cons....
  7. 1990 Mustang Cam Advice
  8. Can I use these Valve Covers? 1992 Mustang GT
  9. Auto trans stays in 3rd in wot
  10. A Good Deal on gt40 intake?
  11. 1993 Mustang, Alternator Output Question
  12. 1993 Mustang steering upset, can it be fixed?
  13. sct mail order chip or dyno tune with sct chip
  14. efi to carb conversion question
  15. found my missifre!! just need some more specific help.
  16. Another newb cam question whats the difference hydraulic roller vs. flat tappet
  17. coolant temp sensor change
  18. Need Cam Recommendation for 331 MUST pass emissions
  19. 1988 Ford Mustang Alternator Died!! (PLUS GROUND WIRE)
  20. Suspension Upgrade Packs
  21. What Cam would you recommend for a 331 ?
  22. GT40 heads I.D.
  23. How to gut proportioning valve
  24. BBK H- Pipe for shortys, 1993 Mustang LX
  25. 1986 Mustang LX Steering hose leak?
  26. Heater mode control cable replacment?
  27. Sway bar bushings, 1993 Mustang LX 5.0
  28. engine rattle after rev, 1989 Mustang 5.0
  29. Engine issues after Upgrades in a 1991 Mustang GT
  30. water is going inside my engine, what to do?
  31. Explorer Intake
  32. Summit has arrived!
  33. question on where to locate a part
  34. Is a Adjustable Fuel Regulator Needed (1990 Mustang)
  35. can anybody help with water temp gauge
  36. Tranny will not easily go into reverse (Possible causes / need opinions)
  37. 1989 Mustang GT, Which cam for my set up?
  38. Harsh Ride Need Shock & Strut Recommendation for Softer Ride
  39. 1993 Mustang, Driveshaft vibration
  40. How much should I lower my 1994 Mustang GT?
  41. Should I port heads? What kind of power gain will I get?
  42. Clutch question
  43. Quick Questions About my MAF and throttle body
  44. What heads are better for a 306
  45. 1988 Mustang 5.0 need a new water pump
  46. 1987 ASC Mclaren 5.0 Fuel issues will crank/won't stay running
  47. 1987 Mustang GT warning light
  48. performance upgrade help
  49. I need some Wiring Help 1989 Mustang GT
  50. Is this a bad torque box?
  51. valve cover clearence
  52. The Oil Dipstick
  53. 1992 Mustang, aod speedometer gear for 4.10 ratio
  54. What other mods needed to support Trick Flow Top End kit?
  55. New to the crew need help disk brakes
  56. 1993 Mustang 5.0 small popping or backfiring on acceleration after 5000 rpm
  57. ACT location on 1989 Mustang 5.0
  58. 5.0 oil presure at 40 pounds?
  59. why carb vacuum secondary not opening?
  60. 1989 Mustang, Sway bar bushings
  61. 5.0 and 5.0 HO Engine Information
  62. Gt40 heads on a 1992 Mustang?
  63. What kind of brake fluid should I use?
  64. 1988 Mustang electrical issue
  65. need H pipe for 1990 Mustang
  66. Weld-in Sub Frame Connector question
  67. Quad Shock removal
  68. 1989 Mustang GT: which power steering pulley removal tool?
  69. Torque converters
  70. 1985-1985 Mustang clutch diameter -- is the extra half-inch worth it?
  71. 347 or bigger just asking
  72. Ok i have grinding sounds when starting
  73. 1993 Mustang, popping noise under heavy acceleration
  74. 1993 Mustang GT cutting out past half throttle
  75. Cruise control stopped working now what