PDA

View Full Version : 5.0L Tech

  1. blown T5 trans?
  2. Engine block ID help needed
  3. I need help with my idle
  4. 1988 Mustang gt with cobra computer got an idea about my hesitation.
  5. weight of 1986 Mustang gt convertible
  6. 306 or 331 stroker
  7. HVAC box replacement question
  8. t-5 transmission is messing up
  9. 1989 Mustang GT: Help please with springs and ride height
  10. Suggetions for comp cam with afr 165 heads
  11. Engine Internals question(s) Forged or Cast [advice & opinions needed]
  12. 1993 Mustang 5.0 missfiring while accelerating
  13. 5.0 vs 4.6 Pros & Cons....
  14. 1990 Mustang Cam Advice
  15. Can I use these Valve Covers? 1992 Mustang GT
  16. Auto trans stays in 3rd in wot
  17. A Good Deal on gt40 intake?
  18. 1993 Mustang, Alternator Output Question
  19. 1993 Mustang steering upset, can it be fixed?
  20. sct mail order chip or dyno tune with sct chip
  21. efi to carb conversion question
  22. found my missifre!! just need some more specific help.
  23. Another newb cam question whats the difference hydraulic roller vs. flat tappet
  24. coolant temp sensor change
  25. Need Cam Recommendation for 331 MUST pass emissions
  26. 1988 Ford Mustang Alternator Died!! (PLUS GROUND WIRE)
  27. Suspension Upgrade Packs
  28. What Cam would you recommend for a 331 ?
  29. GT40 heads I.D.
  30. How to gut proportioning valve
  31. BBK H- Pipe for shortys, 1993 Mustang LX
  32. 1986 Mustang LX Steering hose leak?
  33. Heater mode control cable replacment?
  34. Sway bar bushings, 1993 Mustang LX 5.0
  35. engine rattle after rev, 1989 Mustang 5.0
  36. Engine issues after Upgrades in a 1991 Mustang GT
  37. water is going inside my engine, what to do?
  38. Explorer Intake
  39. Summit has arrived!
  40. question on where to locate a part
  41. Is a Adjustable Fuel Regulator Needed (1990 Mustang)
  42. can anybody help with water temp gauge
  43. Tranny will not easily go into reverse (Possible causes / need opinions)
  44. 1989 Mustang GT, Which cam for my set up?
  45. Harsh Ride Need Shock & Strut Recommendation for Softer Ride
  46. 1993 Mustang, Driveshaft vibration
  47. How much should I lower my 1994 Mustang GT?
  48. Should I port heads? What kind of power gain will I get?
  49. Clutch question
  50. Quick Questions About my MAF and throttle body
  51. What heads are better for a 306
  52. 1988 Mustang 5.0 need a new water pump
  53. 1987 ASC Mclaren 5.0 Fuel issues will crank/won't stay running
  54. 1987 Mustang GT warning light
  55. performance upgrade help
  56. I need some Wiring Help 1989 Mustang GT
  57. Is this a bad torque box?
  58. valve cover clearence
  59. The Oil Dipstick
  60. 1992 Mustang, aod speedometer gear for 4.10 ratio
  61. What other mods needed to support Trick Flow Top End kit?
  62. New to the crew need help disk brakes
  63. 1993 Mustang 5.0 small popping or backfiring on acceleration after 5000 rpm
  64. ACT location on 1989 Mustang 5.0
  65. 5.0 oil presure at 40 pounds?
  66. why carb vacuum secondary not opening?
  67. 1989 Mustang, Sway bar bushings
  68. 5.0 and 5.0 HO Engine Information
  69. Gt40 heads on a 1992 Mustang?
  70. What kind of brake fluid should I use?
  71. 1988 Mustang electrical issue
  72. need H pipe for 1990 Mustang
  73. Weld-in Sub Frame Connector question
  74. Quad Shock removal
  75. 1989 Mustang GT: which power steering pulley removal tool?