PDA

View Full Version : 5.0L Tech

  1. 1995 GT w/ Novi 2000, want to build a block?
  2. Mini starter for header install??
  3. 1986 Mustang, Popping noise when car is turned off
  4. Question on tuning and exhaust
  5. 1988 Mustang, Gas and oil meters are messed up
  6. I want the loud rumble sound!
  7. Timing questions, I need some help?
  8. 1989 Mustang LX, I have very low idle!
  9. 1989 Mustang randomly dying
  10. 1989 Mustang, 306 with B cam, what else to do?
  11. wierd issue starting my 1991 Mustang gt
  12. Window regulator parts - 1993 Mustang convertible
  13. 1991 Mustang performance chip caused CEL to come on
  14. 1987 Mustang 5.0 won't start when cold
  15. Should I reset the codes on my 1990 Mustang LX before doing a self-test?
  16. 1987 Mustang GT drivetrain vibration
  17. 1989 Mustang LX, horsepower question
  18. will 1994-1995 Mustang 8.8 axles go into 1987-1993 Mustang?
  19. 1993 Mustang LX, Throttle response changes
  20. My Catalytic Converter's glowing, why?
  21. upgrades too much for Speed Density? 1987 Mustang 5.0L
  22. Kenne Bell for Fox body, anyway to intercool it?
  23. Pull Trigger on Stroker Kit from Scat
  24. okay so, Valve cover Gaskets?
  25. 5.0 F150 help from you foxbody guys
  26. 1989 Mustang, any transmission adapter to install a Muncie?
  27. 1986 302 HO long block Q?
  28. Axel bearings howling?
  29. will this work: '87 water pump w/ '69 timing cover?
  30. 4 cylinder to v8 swap trouble
  31. Tranny wire at speedo gear?????
  32. 1985 Mustang, random no spark with new TFI
  33. 1988 Mustang LX, Throw out bearing
  34. 1985 Mustang tie rod ends
  35. 1985 Mustang tie rod ends
  36. Help with Tach Placement
  37. 1990 Mustang LX 5.0 failed nox portion of smog check.
  38. Flywheel Question?
  39. Blocking EGR plate from oil/water lines, what will it do?
  40. cam questions Comp Cams 35-518-8?
  41. 302 Mustang Engine id
  42. 1992 Mustang Faceplate gauge installation
  43. ac delete belt size
  44. aod to tko 600 swap is done but runs rough
  45. 1988 Mustang 5.0 with new heads won't start
  46. new project dropping a 302
  47. Need help with cap and rotor dont know which to get?
  48. spindle-strut play
  49. How to set TPS on 5.0
  50. 351 short block
  51. Need Help choosing A Cam
  52. Need suggestions on this.....
  53. Help With gt 40 Heads
  54. Fresh motor leaked all its oil out
  55. Help with 1988 Mustang GT horrific noise
  56. Trans Brake VB AOD
  57. 1987 Thunderbird rear end swap info
  58. 1990 Mustang GT 5.0 Relay Help
  59. What would cause the cam to push forward at a angle and break the harmonic balancer
  60. What block is this?
  61. I have turn signal issues after heater core swap....1987 Mustang GT
  62. what sends the signal to the tachometer? 1989 Mustang LX
  63. questions about running 24lb injectors
  64. 1991 mustang gt 5.0 high idle
  65. 1990 Mustang GT 347 carbed idles at 1000 RPM
  66. idle issues and dying
  67. 1990 mustang convertible rear window seal replacement
  68. turbo 5.0 pcv routing
  69. problems with wiring diagram on 1990 mustang LX 5.0
  70. 331 handle a twin turbo?
  71. What do you think of these...??
  72. rear sump oil pan, need a dipstick for it
  73. need 351 swap info for my 91
  74. EGR removal question on 1986 Mustang GT
  75. 5 lug conversion, will these rims work?