- Need help with speedometer and cable problem on 1986 Mustang!
- t-56 camaro to 5.0 swap is it possible?
- Huge violent vibration! It can happen to you!
- cheap trickflow heads
- what are the benifits of upgrading the fuel system?
- Whining Noise at wheel
- A cleaner engine bay
- 5.0 Mustang - Biggest Cam with Stock Mass Air Computer?
- Exhaust leak @header flange/h pipe joint
- Help! 1995 Mustang GT intake manifold gasket leaking oil?
- 1995 Mustang Tune-up! What Replacement Parts are best for Performance?
- Lean code on '95 GT, O2s? Ideas?
- my 1986 Mustang 5.0 runs super rich and lopes real bad. got any ideas?.
- Locked up brakes... now somethings wrong
- What is pinging?
- check engine light comes on momentarily
- 5.0 blocks all the same?
- Fuel economy with 3.73 or 3.55 gears?
- Intake milling on 1993 Cobra Mustang?
- best cam for mass air 5.0
- Setting the Timing on a 5.0?
- lifters making noise?
- Go with Carb or stick with EFI
- Spedo gear for 4.10's?
- 1991 Mustang GT, No heat... Thermostat?
- Installing Front Coil Springs?
- 1988 5.0 Mustang Long Tube Headers. Help!
- lost t-top keys?
- which engine to replace 85 5.0
- Anybody with an f303 cam
- Will header fit on my heads
- 4 CYL to 8 CYL Swap???'s (ECU & Harness)
- Should I re-ring or replace 5.0L engine?
- which intake set up best for my 1992 Mustang 5.0?
- How much power can GT40p heads get? Are they worth the money?
- getting bored with the 86...
- Modded 1986 Mustang GT Slower than V6! Whats Wrong?
- What injector size should I go with?
- Would changing throttle body give quicker acceleration?
- Need Help! Uncommon Throwout Bearing Problem with 1986 Mustang GT?
- Help! Tightened down valves on GT40P heads but they are still partially open?
- How do I install an MSD Blaster 2 coil and what else do I need to buy?
- Do I also need dual wide band air fuel with dual exhuast?
- Alignment issues! Will caster/camber plates give me more room to adjust?
- What ignition upgrades should I do on 1995 Mustang GT? MSD?
- Help! T-5 Transmission grinds going into 3rd and 4th?
- Quick question about heads.
- Need help with 5.0 cam sizing!
- do i need to change my trans
- 86 lx 2.3 computer ?
- BBK+Gran vs C&L
- What to do with $5,000?
- Performance of a 347 stroker
- What gears do i have?
- is it worth it to go to 1.6 rr instead of stock 1.59's?
- Gains from 1.6 Roller Rockers Over stock 1.59's?
- Fuel Pump problem... any ideas??
- kyb gas adjust shocks and struts ?
- transmission whine // Next Mod
- how much gear oil should i use?
- Auto Meter Temp Guage Fitting
- Check engine light
- Chromoly is it worth it?
- Cobra brake lines?
- Heater problem! No hot heat only warm in my 1992 Mustang?
- Is it worth running roller rockers with my GT40 intake setup?
- How much difference will 347 stroker make vs 302 5.0L?
- kenne bell question
- Intercooler or blow off valve
- Running Hot after Removing Distributor for intake swap on 1988 Mustang GT 5.0
- smallest tire size
- De Accelerating Issues?
- Rear End making wiffing noise
- Need help installing 1996 dual electric fan in my 1990 Mustang!
- twin turbo whats wrong