['Pure Breed']

I've read a few post where bridging the front subs with the factory amps have been done. I cant find a how to. Is it easily done? Where is the factory amp?

[bigwilly43729]

The factory amp for the door subs is behind the dash on the drivers side; not the easiset place to get to. Why would you want to bridge them? They hit pretty hard as-is. It would likely just cause more rattling in those door panels than is already there.

['Pure Breed']

ya. good point. i read about it in a few posts . sounded like something people were doing to get a little more power out of them.

[bigwilly43729]

I have an aftermarket HU with the special harness that allows them to play and they are perfect. I almost regretting the 12's that I have in the trunk sometimes.

['Pure Breed']

lol! dont tell me that. im having two 10's installed in a couple hours!!!

[a_manifestation]

I have read about this in several posts. But still can't find the how to instructions. I have searched this website from top to bottom and even looked in STL's closet full of left-over mods.

I would also like to find out a couple of more things about the stereo and the front subs.

1- Where is the crossover on the door subs? Are they in the radio, the amps, or on the actual speaker? I am getting ready to change the head unit and speakers.
2- How do you bridge the door amps?
3- Anyone with the Shaker1000 swap their subs in the trunk?
4- Which door speakers allow you to reuse the factory covers with little to no modifications? (I like stealth installs)

Thanks for the information in advance, ya'll.

[blak05]

Kicker SSMB8 SS Series 8'' midbass speakers at Crutchfield.com flush-mount depth 2-5/16"

found these in one of the audio forums here....
I was under the impression thet the door subs each had there own small amp, but could be wrong..I'll look somemore

[jefflayton]

Bump to top. I too would like answers to the questions above.