[RCRacer94gt]

i have a 1994 gt and it has keyless entry but no remote. I have my remote from my old 95 Taurus. Would it be possible to Program it to my cars unit?

[lcurle]

yes, just take it to Ford and tell them "It stopped Working" should reprogram it for you. Unless it is an after market keyless entry.

[RCRacer94gt]

Is there any charge when they do it? Is there a way i can do it myself? Thanks. At least i have hope.

[NOGO50]

http://forums.mightymustangs.net/index.php?showtopic=6401

To program (or reprogram) keyless entry remote transmitter into the remote keyless entry module, perform the following steps:

1. Turn ignition switch to RUN or ACC position and momentarily short the two terminals of the Program Connector (two-pin connector next to the remote keyless entry module. Remove LH luggage compartment trim panel to reach the connector). Both doors should lock and then unlock. Remove shorting pin.

2. Press any button on keyless entry remote transmitter. All front doors should lock and then unlock to verify that keyless entry remote transmitter has been programmed.

3. If door locks do not respond, press button again (up to three times maximum with the same keyless entry remote transmitter).

4. Repeat Step 2 to program additional keyless entry remote transmitters into the remote keyless entry module (up to a maximum of four keyless entry remote transmitters).

5. Turn ignition switch OFF. Both doors should lock and then unlock.

6. Check operation.

http://forums.mightymustangs.net/sty...t_snapback.gif

[typerider]

just wanted to say thanks for posting that step by step. came up on a google search i did a while back when i was trying to figure out how to program a new remote on my '95. never had one since i got the car and the guys at the dealership didn't know how to do it. saved me a lot of time and frustration. respect!