[XaviersDestiny]

On my 1967 a few days ago my door jammed shut and locked and i cant unlock it with the key or by pulling the nob up so any ideas on how to fix it? or remedy my problem?

[Tylers67Project]

Mine does the same thing I tried a crobar and couldnt get it open. Then I found out that the 67's were notorius for this. Keep pulling the lock up and down at diferent angles and it should pop up. They get stuck half way and you have to just pull it up and down every time. I dont think there is a permanent fix though. Hope this helps

[drummingrocks]

Originally Posted by Tylers67Project

Mine does the same thing I tried a crobar and couldnt get it open. Then I found out that the 67's were notorius for this. Keep pulling the lock up and down at diferent angles and it should pop up. They get stuck half way and you have to just pull it up and down every time. I dont think there is a permanent fix though. Hope this helps

Dude....a crowbar?! How badly did it damage your door?

[Tylers67Project]

Not that bad i bent it back with a hammer. I know pretty dumb.

[RSALSUP]

Sounds as if you can take the interior door panel off and get inside the door, if you haven't locked yourself out. Good Luck

[flash-1295]

Just pull the interior door panel like rsalup said. Once you remove the arm rest and window crank the panel should pull straight out. You can carefully use a flat screw driver to pry the first corner straight out then work your way around the edge pulling straight out till you can pull the whole thing off. There may be a plastic water shield behind that as well. You can just pull the part near the door lock loose without removing the whole thing if you don't want too. I would bet that the ring fastner to the lock has come apart. Just move the lock up and down and follow it to see where it is connected. (or not connected).