what do you think?

351mustang65 · 08-20-2008

what do you guys think of this setup for my 351w that's going in to a street car. edelbrock rollin thunder roller cam and lifters crane roller rockers edelbrock performer rpm heads and air gap intake with 650cfm speed demon carb

ieatdrt · 08-20-2008

Sounds like you have a stout combo on your hands. Should put out around 450-500 at the flywheel depending on the compression ratio. What are you mating it too?

351mustang65 · 08-20-2008

a pretty much stock 69 351w block trans is c4 with a shift kit and i think i have a 9 inch for the rear but im not sure on the gears its coming off a old gremlin

351mustang65 · 08-21-2008

do you think a stock bottom end could hold that much hp?

351mustang65 · 08-24-2008

and if i got bear performer rpm heads would i have to do any work to them to put roller lifters and roller rockers on them?

351mustang65 · 08-28-2008

wow you guys know so much its so nice you would use that to help someone who dose not know as much as you. thanks for all the help not!