[aharemza]

I am in the process of restoring a 64.5 Mustang Which looks like it was backed into a post and bent the, tail light panel, Slight buckle in right rear quarter panel under back of rear window, a small bukle on the inside edge of left rear frame rail before the hump,right frame rail buckled bad & right leaf spring buckled. There is also buckle in the rail in the middle of the hump and in the wheel well by the back seat support. The entire floor will have to be replaced in the trunk due being bent & rusted out. The rear frame rail on the right side is buckled up pretty bad and will have to be replaced.

My Question is would it be easier to try and take the buckle out of the center of the hump or replace the entire rail and straighten the sheet metal?

The condition of metal on the frame rail is good & very solid.

Any advice would be appreciated

[sam03rc]

hey i have a similar problem im working on a 66 conv. and it was rear ended in the right rear and the floor and rail on that side it buckled and rusted and i would like to know too what you do?