1971 Mach 1 Floor Board Information

Astrockm1988 · 08-02-2009

Hello, I did a restoration job, while I was in college, It was on a 71 Mach 1. Me and one other person made complete floor boards for it, from flat pieces of steel, then I made custome seat panels (what the seats bolt to). Here is all the measurements and bends and stuff that I had to take and do to make them, This is for someone looking to save some money on their restoration project. If you have any questions or want to see pictures of them after they were done or the floor boards, don't be affraid to ask. I will be posting them on my profile shortly. Good luck to everyone out there.

1971 Mach 1 Custom Seat Panel Measurements

Lip 1 1/2" all the way around
A 90 degree break down going from 1 1/2" to 1/2" on the back
From the 90 degree break to the middle of the bolt hole 1 5/8" (rear)
From the 90 degree break to the middle of the slot 2 1/2" (rear)
From the right lip to the middle of the bolt hole 5 1/2" (right rear)
From the right lip to the middle of the slot 5 1/2" (right rear)
From the 90 degree break to the break up 10 1/4"
From the 90 degree break to the break down 10 1/4"
The break up 2 1/2" long, Left side 4" wide, Right side 7 1/4" wide
The break down 4 1/2" long and 8" wide
The flat spot on the break up 1 1/4" long
A 90 degree break off the flat spot 2 1/4" long
The top corner to the break down 1 1/2" long (straight edge sitting on the break down)
Right side to the middle of the slot 4 5/8" (front)
Right side to the middle of the bolt hole 5 1/2" (front)
Left side to the middle of the slot 2 1/2" (front)
Left side to the middle of the bolt hole 1 5/8" (front)
From the bottom lip to the middle of the slot 1 1/4" (front)
From the bottom lip to the middle of the bolt hole 1 1/2" (front)
Slot size: 1 1/4" by 3/4"
Center to center of the slots 14" (rear)
Center to center of the bolt holes 14" (rear)
Center to center of the bolt holes 14" (front)
Center to center of the slots 14" (front)
Panel width: 24 1/2" front, 24" (rear)
Panel length: 19 3/4" left side, 20 3/4" (right side)